Tank oil temperature protection: When the oil temperature in the tank exceeds the standard setting value, the oil temperature protection device sends a signal to suspend the use of the elevator. The elevator can only be started when the oil temperature dropsSetting requirements: The foundation and foundation of the construction electric elevator should meet the requirements of the user manual. Before installing the construction electric elevator, the foundation should be inspected and accepted according to the requirements of the specifications. Only after passing the inspection can the installation be carried out.Pisa,The use of fully autonomous electric elevators can create more benefits and ensure safety in all aspects.There is no need to set up a computer room above the shaft like an elevator, and the top floor height can be installed at least . meters.Eseka,During the use period, the user unit should organize professional technical personnel to inspect the construction electric elevator monthly according to the standard requirements, and record the inspection results.The entrance of each landing platform must be equipped with a landing door, which must open towards the landing platform side, and the door bolt must be set on the side next to the construction electric elevator.Horizontal lead screw mechanical electricity

During normal operation, the horizontal distance between the closed cage door and the closed landing door should not exceed mm. Otherwise,PisaMagdeburg, measures should be taken to make it meet the requirements or side protection devices at the entrance of the landing station that meet the requirements should be equipped. The distance between any opening between the side protection device and the hanging cage or landing door should not exceed mm.When adding hydraulic oil, and how many lifting operations need to be carried out during filling to fully fill each position of the hydraulic oil. Therefore, when filling, try to add as much as possible, and then test and run the machine empty to see if it reaches the rated position.The foundation base or embedded parts should be fully embedded in the concrete foundation plate.original,The scaffolding of the parking platform should be laid tightly and firmly.Implementing multiple shifts of homework should fill in and submit records according to regulations.Principle of electric elevator rotary valve: When the electric elevator rises, the rotary valve will automatically open. To close the plug valve, it is necessary to first turn the handle to turn the plug to a degree position until it is closed, and then turn the transmission handwheel to lower the plug and achieve sealing.

Speed limiter. To prevent the driving speed from exceeding the normal speed. A speedometer should be installed (not required for floors below or including the second floor), which is an individual mechanism that is integrated with a safety clamp; The entrance and exit of the passenger compartment should be equipped with safety doors. Public places, family dormitories, which must open towards the landing platform sideThe entrance of each landing platform must be equipped with a landing door, and the door bolt must be set on the side next to the construction electric elevator.Before use, we should observe whether there is any damage to the electric elevator. We can conduct a no-load test to raise and lower it. If there are any damaged parts,PisaHail Brown, they should be replaced in a timely manner to prevent major accidents.Operating cost advantage and low failure rate: Due to the use of advanced hydraulic systems and good methods, the operating failure rate can be reduced to a low level.Pisa,PisaZhuanghe,There is no need to set up a computer room above the shaft like an elevator, and the top floor height can be installed at least . meters.Operating cost advantage and low failure rate: Due to the use of advanced hydraulic systems and good methods, the operating failure rate can be reduced to a low level.Civil engineering advantages: The pit depth of the guide rail type lifting platform is generally around -mm, and the top layer is not affected. It can be customized according to the location and environment.