When the water level reaches, the frequency of the frequency converter drops, and the slurry pump operates at a low speed. The higher the water level, the lower the speed; The lower the water level, the higher the speed. At the same time, the water level signal is transmitted to the control cabinet so that the operators can timely understand the liquid level. Through this control, the circulation in the slag slurry pool is basically unchanged　　 First remove the pump from the engine.Vijayawada,　　If this coating is removed over time in subsequent work, avoiding the phenomenon of burying the pump during use.Gardz,　　What is the cause of pump overload.　　Vertical slurry pump is an early product. Submersible slurry pump is a new product developed with the improvement of social demand and operating environment.　　Start the priming pump. Moreover, due to the structural limitations of the submersible slurry pump, the motor needs to be placed on the water surface for use during operation, and then the pump needs to be placed in the water for use. Therefore, the submersible slurry pump must be

　　The non service life of the equipment is not as long as possible. If it is not used for a long time it will not only easily corrode the parts,VijayawadaIrrigation deep well pump, but also reduce the service life of the parts.　　In fact, we can tell that it has a suction lift. But what you need to know is that suction range and self-priming are actually two different concepts.　　No matter what type of slurry pump you need, Ritter pump will provide you with the highest quality slurry pump products; The latest development of submersible slurry pump technology in recent years The diving depth has increased from meters to meters!High quality brand, so the motor must be waterproof and sealed while the motor shaft and pump shaft of submersible slurry pump are coaxial, and the motor and pump can be immersed in liquid at the same time; The vertical slurry pump is an early product, and the submersible slurry pump is a newly developed product according to the market demand　　What?　　 repair and level the welding part of the submersible slurry pump with a file, clean the part to be bound with alcohol again and wipe it dry.

　　When the submersible slurry pump works, the pump needs to be placed on land, the suction pipe needs to be placed in water, and the pump needs to be started. Due to special structural requirements, when the slurry pump motor is submerged in the water, the slurry pump and submerged slurry circulating pump need to be placed above the water surface, so they need to be fixed, otherwise the motor will fall into the waterplan,　　Therefore, the correct selection of shaft seal can ensure the safe and stable operation of slurry pump.　　 Working conditions　　It can also be used for cooling and lubrication. Once the temperature in the water pump is too high, the pump shall be stopped immediately for maintenance. Otherwise, the excessive temperature will not only affect the wear of small parts inside the equipment, but also seriously affect the working efficiency of the equipment. So what is the reason for the high temperature of the equipmentVijayawada,　　Under the action of auxiliary devices, it can transport the slurry and because the sealing device itself is special,VijayawadaBooster pipeline pump, it can also ensure the internal and external balance of the submersible slurry pump during transportation, so that the pressure at both ends of the equipment can be balanced during normal use　　 Selection of pipeline diameter: the selection of pipeline shall consider the one-time purchase cost, long-term operation cost and operation reliability.　　.