GirishkVertical slurry pump,

　　 First of all,GirishkISG single stage vertical pipeline pump, let&#;s understand the causes of insufficient liquid supply: If the liquid level stored in the circulating liquid storage tank is lower than % then insufficient liquid supply will occur when it is in use. Or the pump adds too much lubricating oil, which leads to accumulation　　 If it is found that the impeller is damaged and the liquid supply is insufficient, it is necessary to replace the new impeller in time for use.Girishk,　　 Types of motors for deep well pumps　　Moreover, the leaked flammable, explosive and toxic liquid will cause fire, explosion and poisoning, and the consequences will be unimaginable.Zaporizhzhya,　　 The bus voltage where the motor is located is V. Due to the uneven cable voltage drop and load distribution, it is also possible that the temperature is too high due to the low voltage of the water pump.　　Auxiliary mixing or spraying device shall be equipped for easier operation. When the motor is submerged there is no need to build complex ground protection and fixed devices, and the management is easier. The mixing impeller directly contacts the deposition surface and controls the concentration through the diving depth, so the concentration control is more free. Equipment directly submerged　　The first stage impeller of the pump is disassembled; It is also necessary to screw down the connecting nut between the water absorption section and the bearing body and the bolt on the bearing pressure connection, so that it is convenient for us to disassemble the bearing parts; When the shaft is pulled out from the suction section, so it has an irreplaceable position when it is used. What is its own structure when it is used.　　 within the estimated installation depth, the minimum inner diameter of the well is mm　　All kinds of newly designed mechanical seals of submersible slurry pumps contribute greatly to the growth of market share.Potential development,　　At the same time, the supporting pipelines in the pump room shall be provided with vibration isolation elasticity.　　Friction resistance due to bearing and packing; Friction between impeller and water during rotation; The vortex of water flow in the pump, gap reflux, inlet and outlet impact and other reasons. A part of the power must be consumed, in which the constant active power　　Fourth, dust flow, motor power, impeller speed, pumping rate, maximum particle and weight.

　　 Before starting the submersible slurry pump, the rotor of the rotating pump shall be smooth and even, the outlet sluice valve shall be closed, and water shall be injected into the pump to ensure that the pump is full of water without air.Quality management,　　The two have certain commonalities. They are both submersible. As the name suggests, the pump is in an invasive state when running. The submersible slurry pump is a kind of submersible pump, but generally speaking, people often say that the submersible pump refers to the clean water pump, such as the submersible pump for domestic water and farmland irrigation and pumping　　The microcomputer controller displays E: cause: check whether there is a fault on the inverter panel display. If there is a fault, please record it; Solution: power off the circuit breaker QF, reset it, and contact our after-sales service department.　　It is located in the middle, so it seems that many regions have good effects when using it.Girishk,　　The structure of the submersible slurry pump will be more intuitive. First, the equipment will use centrifugal force to drive the liquid from the impeller to the outer edge and obtain energy, and then leave the edge of the impeller at a higher speed　　 The rotor assembly is designed according to the actual situation, and the operation is more stable!　　The of descending axial force can be used for slurry transportation in power plants, hydraulic and other professions; The mechanical seal is tight and reliable, and the leakage probability does not exceed drops /min, which is mostly used to transport flammable, explosive,GirishkWear resistant slurry pump, toxic, strong corrosive and valuable liquids or materials with high temperature, high pressure and low temperature.