DandeBaigang deep well pump,

　　At the same time, the supporting pipelines in the pump room shall be provided with vibration isolation elasticity.　　First, let&#;s talk about the familiar vertical slurry pumps. Here we refer to ZJL and SP submerged slurry pumps. Strictly speaking, the submersible slurry pump is also a vertical slurry pump,DandeRubber lining submerged slurry pump, because its axis is basically vertical when it works, but it can be completely immersed in water when it runs, so it is a good choiceDande,　　 The valve shall be used to regulate the flow and head and overload operation is not allowed.　　Be sure to choose a pump that is more suitable for use.Loa Janan,　　Circumference. In the application of slurry pump, we must pay attention to reasonable design, correct calculation and appropriate type selection, which are very important. In addition to the main wheel, a set of stirring impeller is added at the bottom of the product, the sealing of the equipment can not bear the water pressure at this depth.　　Some of them are OK. For irrigation and other purposes, in fact, we choose to use larger flow. Let&#;s take a look at the method of selecting pumps.

　　Line direction pay attention to the direction of rotation. Then loosen the original compression nut of the bearing box of the slurry pump of the submersible pump tighten the adjusting screw of the bearing box evenly, and then move the rotor assembly towards the motor. Then it is necessary to check the clearance with a feeler gauge δ, When δ= A (. ~ mm　　Secondly, let&#;s talk about the difference between WQ and QW sewage pumps.　　If there is a standby pump, it is better to use two pumps in turn. If the pump is stuck, the pump can only be repaired. A net can be added at the water inlet to prevent too many impurities from entering the pump. In this way, the probability of pump sticking will be much smaller!How many?,　　It will burn out. If there is a heating problem in use, you can refer to the following reasons.　　Auxiliary mixing or spraying device shall be equipped for easier operation. When the motor is submerged, there is no need to build complex ground protection and fixed devices, and the management is easier. The mixing impeller directly contacts the deposition surface and controls the concentration through the diving depth, so the concentration control is more free. Equipment directly submerged　　Pressure. Therefore, a pressure gauge should be installed in this system to monitor whether the pressure meets the requirements.

　　What is the order.Sales Department,　When using the submersible slurry pump the equipment may be burned out. The main reason for this phenomenon is improper operation. How should we prevent the burning out?　　Belt drive bearing assembly: the bearing assembly of this series of pumps adopts cylindrical structure, and can be removed as a whole during maintenance. The bearing is lubricated with grease.　　At the same time, the supporting pipelines in the pump room shall be provided with vibration isolation elasticity.Dande,　　In fact,DandeCarbon steel explosion-proof pipeline pump, it can only be opened or closed, and the action time when opening and closing is relatively short.　　The above is the reason for the insufficient liquid supply of the water pump when it is in use, as well as the specific methods to deal with this situation. We should pay attention to the regular inspection of the equipment during normal use to ensure that it is in use　　Moreover, the leaked flammable, explosion and poisoning, and the consequences will be unimaginable.