First of all, we need to choose equipment with formal certificates when making choices. We must avoid buying some obsolete or inferior products. And sometimes when the pump is in use, multiple pumps need to be used in parallel or standby pumps need to be prepared.　　What is the order.Bilai, heat it with an electric iron, and infiltrate tin evenly.Buenos-Aires,　　Rate.　　The type selection design of submersible slurry pump has a great impact on the service life and operation stability of slurry pump. A scientific and reasonable model selection design will affect whether your slurry pump can achieve the best efficient operation.　　The disc friction loss of the slurry pump impeller will decrease with the decrease of the impeller diameter, so that the pump efficiency of most low specific speed pumps will improve slightly after the impeller is cut. After cutting,BilaiISG single stage vertical pipeline pump, keep the blades overlapped to a certain extent, and the degree of blade overlap will decrease with the addition of specific speed

　　In the mud pump, and the resultant force is the sum of the two forces. If the submersible slurry pump is equipped with an auxiliary impeller, the liquid effect is on the auxiliary impeller　　 If the deep well pump is not used continuously after running in the well, it should be started up once a week and run for - minutes to prevent the electric pump from being started due to corrosion.　　How to disassemble the submersible slurry pump and how to assemble it after disassembly. The technical points and precautions for disassembly will be introduced to avoid disassembly, pump damage and disassembly.Good quality,BilaiBaigang deep well pump,　　 It is also possible that the fan blades of the pump are few and the air volume is insufficient, resulting in poor heat dissipation effect.　　 strip the outer layer of the cable to expose the copper wire for to mm, gradually thin the rubber near the wire core, grind it to the oxide layer on the wire core, wipe the wire core with alcohol (or hydrochloric acid), wrap the insulation layer and sheath layer and dry it naturally.　　 install a valve to inject water at the water inlet and outlet. This method is to install a valve on the water inlet pipe of the submersible slurry pump and connect the water pipe to inject water into the pump. This is a common and simple method.

　　Rate loss, so shaft power = effective power + lost power.Latest consultation,　　 When starting the slurry pump, the outlet gate valve shall be (closed or slightly opened by /. Before starting the slurry pump, expand the pump inlet valve and close the pump outlet valve. Then start the pump. After the pump is started, slowly start the pump outlet valve. The size and speed of opening the pump outlet valve should be based on the fact that the pump does not vibrate and the motor　　Driven by the pump products represented by stainless steel pipeline pumps, the whole pump industry is constantly moving forward, and with the raw material market driven by this new stainless steel materials are constantly coming out. The continuous improvement of various technologies and specifications has driven the whole industrial chain to a higher direction.　　 The gas inadvertently entered in the equipment is discharged and good sealing performance is ensured.Bilai,　　 install a valve to inject water at the water inlet and outlet. This method is to install a valve on the water inlet pipe of the submersible slurry pump and connect the water pipe to inject water into the pump. This is a common and simple method.　　 The rotor assembly is designed according to the actual situation,BilaiFire deep well pump, and the operation is more stable!　　This phenomenon shows that the failure of the pump is not only a material problem, but also reminds the pump designers and producers that in addition to good working conditions, the pump should also have good corrosion resistance, high reliability and long service life. The pump shall be designed in addition to the conventional design method of fluid mechanics