It can be wrapped with moisture-proof paper for moisture-proof protection. It can also prevent oxidation to a certain extent. If cracks or serious corrosion are found, they must be isolated.Insert the pipe into the top of the bayonet,e the sleeve on the pipe to evenly apply the flux on the joint, and confirm that the pipe is inserted into the bottom of the socket, then wipe off the excess flux, and the joint is assembled and can be heated.Wich ambry,After welding, it can be annealed at ~ ℃ to prevent & quot; self cracking& quot; by stress.After the pipe is cleaned, the welding flux and flux shall be immediately applied to the interface and the bayonet clearance. Sufficient flux shall be thinly coated on the mating surface and assembled immediately, so that dust and dirt will not pollute the capillary gap.Koudougou,When welding, just add enough filler metal to fill the capillary gap. Too much filler metal will only form a ball at the bottom of the joint or run into the pipe.Red copper inventory in key areas has risen continuously, but the total pressure is not big. From the current overall inventory situation of the main distribution centers Wu an, Jiangyin and Lecong, the inventory level remains relatively moderate, and the pressure on the market is relatively small. In Wu an market, according to the data, as of May , the total inventory of medium and thick plates in Wu an was close to tons, increasing by tons on a weekly basis. In late April, it reached tons lower in the year down tons from the high level after the Spring Festival, and rose for three consecutive weeks. In terms of the ovquantity, it should be said to maintain a relatively moderate level.The ex factory price of Linyi Pipe Factory has decreased by yuan for cash Baocheng ( * mm, the same below) yuan, yuan for Jin Zhengyang yuan, yuan for Ruigang Lianlian, yuan for Baoda yuan yuan for Meixin yuan, and yuan for Taizong yuan.

Because of the characteristics of copper itself, it is very easy to rust and corrode in places with high ambient humihumidity. If we often use it,Wich ambryRed copper bar, the problem will be smaller but if it is placed for a long time, the copper will be damaged. Many people do not know how to treat the copper surface? Now let the staff answer for you.Welding sequence of copper pipe Before heating, apply the flux to the position to be welded.In terms of steel billets: at :, some steel billets in Changli were reduced by , and the current carbon square billets were delivered with tax of yuan. After the th National Congress of the Communist of China, the market had doubts about the uncertainty of environmental production restriction and was still waiting for a clearer direction. Therefore, it can be seen that at this stage, there was no unilateral market for either futures or cash, and there was no definite pattern of ups and downs. According to the monitoring data of Lange Iron and Steel s cloud business platform, as of the time of publication, Tianjin Youwelded Line: the steel mill reported: Rongcheng # yuan/ton, B yuan/ton; Jiujiang # - # to Tianjin yuan/ton; The arrival price of Xinji Aosen # is yuan/ton, and that of B steel is yuan/ton; Jiyuan # yuan/ton, B steel yuan/ton; Fulen # yuan/ton; Weigang # yuan/ton, B steel yuan/ton.Where to sell API,Remove the flame. If the filler metal does not melt, continue to heat the joint and try again. The melted filler metal is sucked into the casing port according to the capillary effect until a complete filler metal ring appears on the casing port. Remove the flame Pay special attention not to let the flame directly contact the filler metal. It should be the heat at the joint that melts the filler metal. In order to clean the copper pipe, and shall be cleaned after brazing. The so-called & quot; self-cleaning& quot; fluxes are generally not recommended because of their corrosivity.Five of the five major application fields of copper plate, copper bar and copper tube: copper is used in medicine. In the s, Chinese medical inventors Liu Tongqing and Liu Tongle found that copper has extremely strong s, and successfully developed the corresponding & quot; Cancer Suppressing & quot;, which is successful in the near future.Red copper inventory in key areas has risen continuously,Wich ambryAluminum rod, but the total pressure is not big. From the current overall inventory situation of the main distribution centers Wu an, Jiangyin and Lecong, the inventory level remains relatively moderate, and the pressure on the market is relatively small. In Wu an market, according to the data, as of May , the total inventory of medium and thick plates in Wu an was close to tons, increasing by tons on a weekly basis. In late April, it reached tons lower in the year, and rose for three consecutive weeks. In terms of the ovquantity, it should be said to maintain a relatively moderate level.

On the other hand, in the steel plant, the lock price of the steel plant has been falling all the time, and the order receiving is poor. The capacity utilization rate of the steel plant is low, but the market is still in oversupply. The stock of the steel plant and the spot stock are both risirising, so the market price has fallen sharply. Subsequently, the futures market rebounded in a wave, and the spot price also increased with the increase. There was an instant of large volume of transactions. However, with the decline of black futures, the market transaction volume shrank significantly. In addition, the inventory pressure was high, traders shipped at low prices, and the spot price fell under pressure. Due to the strong drop resistance of medium and thick plates, the drop amplitude and rate are less than those of threads.recommend,It is mainly used to manufacture electrical devices such as generators, buses, cables, switchgear transformers, and thermal conductive devices such as flat plate collectors for heat exchangers, bronze and white copper. Pure copper plate is a purplish red metal, commonly known as & quot; copper plate& quot;, & amp; quot; red copper plate& quot; or & quot; red copper plate& quot;.Corrosive agents such as calcium bicarbonate, inositol hexaphosphate, etc. are added to the water to regulate the PH value of the water and the corrosion symptoms.Overview of three production methods of copper tube Copper tube is a very important material for copper materials. There are many ways to complete the production of this copper tube. For copper pipes, the following three methods are generally used to produce materials. The copper tubes produced by these three methods are not only very good in performance, but also very convenient to operate. There are three production methods for copper tube, so what are the three production methods for copper tube?Wich ambry,In terms of steel billets: at :, some steel billets in Changli were reduced by , and the current carbon square billets were delivered with tax of yuan. After the th National Congress of the Communist of China, it can be seen that at this stage,Wich ambryLow alloy plate, there was no unilateral market for either futures or cash, and there was no definite pattern of ups and downs. According to the monitoring data of Lange Iron and Steel s cloud business platform as of the time of publication, Tianjin Youwelded Line: the steel mill reported: Rongcheng # yuan/ton, B yuan/ton; Jiujiang # - # to Tianjin yuan/ton; The arrival price of Xinji Aosen # is yuan/ton, and that of B steel is yuan/ton; Jiyuan # yuan/ton, B steel yuan/ton; Fulen # yuan/ton; Weigang # yuan/ton, B steel yuan/ton.Strong connection firmness of copper pipe: the connection between copper pipe and copper fittings is strong.Although the opening continued the weak trend, the intraday transactions improved, and the prices of some copper bar manufacturers rose. From the specific situation, although the manufacturer feedback that the shipment is average, the mentality is relatively calm, the market inventory is not much, and the manufacturer is not willing to significantly reduce the price. In terms of the market, the transaction of strip steel is better than other steel varieties, and the downstream mainly focuses on callback buying without panic inventory clearing. It can be seen that although the steel market continues to shake the overall demand for strip steel remains in a good state.