The end height of the guide rail frame above the high attachment point should comply with the provisions of the user manual.Drainage measures need to be considered around the foundation. (Drain the accumulated water on the foundation).Sauergo taoeryang,Construction electric elevators should be equipped with lower limit switches that are sensitive and reliable.It is understood that the scissor type lifting platform is a widely used specialized equipment for high-altitude operations. Its shear fork mechanical structure provides high stability for the lifting platform, wide working platform, and high load-bearing capacity, diesel engines, using Italian and domestic hydraulic pump stations, and the table top is equipped with anti slip insulation buckle plates,Sauergo taoeryangKoenipus, which have anti slip, insulation, and safety features. Please rest assured to use.Akashi,The scissor type electric elevator is a widely used high-altitude operation special equipment. Its scissor mechanical structure ensures high stability of the lifting platform, wide working platform and high bearing capacity, making the high-altitude operation range wider and suitable for multiple people to work simultaneously. It makes high-altitude operation more efficient and saferThe spacing between wall brackets and the height of guide rails above the high attachment point should comply with the requirements of the user manual.Especially suitable for steel structured factories, suitable for both indoor and outdoor installation.

Emergency manual valve: In case of power failure, it can cause the car to descend to the nearest floor position and open the door. The shutdown device (emergency stop switch) should be installed outside the ground protective fence; b) Pulley room (if any. Pulley room refers to a room where only pulleys or speed limiters and electrical equipment are installed; c) hanging cage top ifWhen the door is closed, except for the gap between the lower part of the door that should not exceed mm, any through-hole and opening size related to the distance between any door and adjacent moving parts, as well as the gap around the door or the gap between parts, should comply with the provisions of Table of GB -.Word of mouth recommendation,Setting requirements: The foundation and foundation of the construction electric elevator should meet the requirements of the user manual. Before installing the construction electric elevator, the foundation should be inspected and accepted according to the requirements of the specifications. Only after passing the inspection can the installation be carried out.The angle between the wall bracket and the horizontal plane should comply with the requirements of the user manual.Principle of electric elevator rotary valve: When the electric elevator rises,Sauergo taoeryangGreensboro, the rotary valve will automatically open. To close the plug valve, it is necessary to first turn the handle to turn the plug to a degree position until it is closed, and then turn the transmission handwheel to lower the plug and achieve sealing.

The scaffolding of the parking platform should be laid tightly and firmly.Click to view,There is no need to set up a computer room above the shaft like an elevator, and the top floor height can be installed at least . meters.Stop the suspension cage.Operating cost advantage and low failure rate: Due to the use of advanced hydraulic systems and good methods, the operating failure rate can be reduced to a low level.Sauergo taoeryang,Drivers of construction electric elevators should hold special construction operations and are not allowed to operate without a certificate.The net height of the landing door opening should not be less than m, and the difference between the net width and the outlet width of the cage door should not exceed mm. When the floor door is closed, except for the gap between the lower part of the door that should not exceed mm, the size of any through-hole and opening related to the distance between any door and adjacent moving parts,Sauergo taoeryangPesaro, as well as the gap around the door or between parts, should comply with the provisions of Table of 'Mechanical Safety - Safety Distance to Prevent Upper and Lower Limbs from Touching Dangerous Areas' GB-.The pump body adopts an integrated pump station, all equipped with imported high-quality pump stations, which can also be selected according to customer requirements to meet customer ideal requirements.