So far as the storage method of copper materials is concerned, we should properly keep the copper products we buy, extend the service life of copper and ensure its performance to avoid unnecessary losses.This week (-, the market price of red copper bar rose, the price was stable to support the market, and the rising of billets at the weekend drove the market up in a wave, and the price of variety wire rods also rose by yuan at the weekend. However, it was reported that the deal was very poor, which led to the price being s table for the next two days. Until Wednesday, due to the negative outlook on the future market and the reduction of steel billets in the afternoon spiral diving, the market lowered the price. Market price changes, Xinji rose yuan on the rd; For the future market, the off-season is coming, the demand is weakening, and the market wait-and-see mood is getting stronger. But when winter comes, the environmental protection inspection is becoming more and more strict, which supports the market. It is expected that the price ofety wire rod will be adjusted in a weak way in the short term.CelingawiCopper is light.After the pipe is cleaned, so that dust and dirt will not pollute the capillary gap.Adrasmon,The market opened today. Although the performance of Zitong Pai futures was modest the overall market has stopped. The market mentality has not changed much sincekend. The price is stable, but some specifications are subject to negotiation,CelingawiT2 copper bar, and the negotiation range is about - yuan. The overall rhythm of the market is stable and cold. In the middle of winter, the overall market in Northeast China has entered the traditional off-season,Celingawi316L stainless steel round steel, and all construction sites have been closed. In addition to the transportation pressure brought by the low temperature, the market was bleak.According to * * new data in September , China s imported iron ore * * * broke through the million ton mark, reaching million tons, a record high; From January to September, China s iron ore import increased by % to million tons, and the annual import volume is expected to exceed billion tons. However, judging from the shipment of imported ores after the National Day, due to the rapid declinecline in iron ore prices, the iron ore price index once fell below $, which reduced the enthusiasm for the shipment of imported ores. In addition, environmental protection inspection has become stricter, and the supply of some domestic mines has been greatly affected. The current operating rate of domestic mines is percentage points lower than the previous peak, which is likely to decline further in the future.In addition, it is not easy to be corroded and can adapt to various environments. It can be used normally at low and high temperatures, so copper pipes need to be selected for many times in other places.

After : on October , continue to implement the measures of stopping and limiting production specified in TZBZ [] No. document. All sintering machines and shaft furnaces using wet desulphurization in iron and steel enterprises in the city were shut down, and sintering machines using semi dry desulphurization continued to be shut down for %. The access of vehicles is alicted. The port collection and distribution vehicles are prohibited from entering and leaving the port area. The city s steel, coking, cement, chemical and other key vehicle enterprises are not allowed to transport vehicles into and out of the plant. After : on October the vehicle enterprises in the above industries will implement % of the peak load shifting emission reduction measures. It is estimated that the average daily consumption of sintering powder in Tangshan will be more than yuan, and the purchase of iron ore may still maintain a small amount of prudence. In addition, due to the influence of industrial users & amp; quot; coal to gas& quot;, the recent performance of coke is weak. Therefore, in terms of steel plant production, the support of raw materials is weak.To prevent core problems of copper tubes, the outlet tempmperature of copper tubes should be well controlled. The cooling capacity of the annealing furnace in the cooling stage should be improved by equipping a refrigeration unit for the annealing furnace, so as to ensure that the outlet temperature of copper tubes does not exceed ℃. By controlling the outlet temperature of copper tubes, the problems of the core of coil tubes and the inner wall of the purging inlet end can be solved.This week (- the market price of red copper bar rose, and the transaction was not ideal. On the bidding day of Shagang last weekend, the price was stable to support the market, and the rising of billets at the weekend drove the market up in a wave, and the price of variety wire rods also rose by yuan at the weekend. However, it was reported that the deal was very poor, which led to the price being s table for the next two days. Until Wednesday, due to the negative outlook on the future market and the reduction of steel billets in the afternoon spiral diving, the market lowered the price. Market price changes, Xinji rose yuan on the rd; For the future market, the off-season is coming, the demand is weakening, and the market wait-and-see mood is getting stronger. But when winter comes, the environmental protection inspection is becoming more and more strict, which supports the market. It is expected that the price ofety wire rod will be adjusted in a weak way in the short term.assets, additives and other chemical components of plastic pipes in copper pipes.In the middle and late ten days additives, although there were good news such as the rise of futures and the increase of production restriction policy in Wu an region, due to the high inventory level, traders had no desire to increase prices,CelingawiSquare aluminum tube, most of them had shipped goods, and spot prices lacked motivation to rise. The market inventory rose significantly. At that time, the market inventory in Handan reached a high level after the festival. The sluggish demand performance for a long time led to the oversupply of the market, red copper, bronze, etc. can be used. Oil stains, fingerprints, oxide layers, etc. on the surface can be cleaned with copper cleaner first.

When stacking, it shall be stacked reasonably and placed first.Sampling inspection,After the pipe is cleaned, the welding flux and flux shall be immediately applied to the interface and the bayonet clearance. Sufficient flux shall be thinly coated on the mating surface and assembled immediately, so that dust and dirt will not pollute the capillary gap.One oftion of copper tubes. The common wave shape is a single copper tube. Hyperbolic means that two different arcs overlap on the same surface, that is, draw arcs in two radii. The red copper tube is a module made of double curves designed according to the drawings. The red copper tube is light in weight, good in rigidity and high in strength. The shapes of the red copper tubes processed are different and can be processed into various geometric shapes such as arcs and spheres. It is beautiful, elegant and colorful. Let s talk about the two main methods of processing and forming the copper tube: The hot processing and forming method is to roll the copper tube to a roughly hyperbolic shape then heat it, then place it on the mold prepared in advance, then slowly beat it with a hammer, finally cut, weld, fold, polish and polish it. The whole process needs to be very careful to ensure the surface quality of the copper tube. This forming method is very suitable for parts with small model and large arc change. When the model size is relatively large and complex, it can be considered to break it into small pieces for forming, and then splice it into large pieces. For such copper pipes, the cost is high and the production period is long. Forming method of roll bending This method is to make some modifications on the roll bending machine, and change one of the shafts into a concave type and the other into a convex type. This method can form a regular copper tube like a sphere, with a small processing range, but it has great advantages for copper tubes with small radians. What problems should be paid attention to when designing the hyperboloid copper tube? Everyone knows that the design of the air conditioning copper tube is very important. To achieve the beautiful shape, exquisite workmanship and fashionable personality of the hyperboloid copper tube, first of all, the design is very critical. Some small copper tube copanies are not mature enough in design and have not enough design experience, so they often have problems in design, Hyperbolic copper tube is very famous for preparing some details that we should pay attention to in the design. The sculpted copper tube is highly decorative, and the production and processing technology of hyperbolic shaped copper tube is relatively complex. Copper tube products with strong aesthetics. According to the design requirements, so the production process of sculpted aluminum veneer is relatively complex.[] Welding process of copper pipe Clean the end and seven ports of steel pipe with steel wool. Do not use abrasive cloth or abrasive paper to clean, because it will affect the clean interface and result in poor welding effect.Celingawi,If the corrosion on the copper surface is found to be slight, it can be erased with linen copper wire, but it is not recommended to apply oil for preservation.If you want to avoid this kind of situation for a long time, you can choose passivation treatment. In this way, not only is the copper surface serious, it can be cleaned under normal circumstances, but it is not a big problem to keep it in the air for one year or more after ultrasonic treatment and immersion treatment, so this effect is very good.Red copper inventory in key areas has risen continuously, but the total pressure is not big. From the current overall inventory situation of the main distribution centers Wu an, Jiangyin and Lecong, the inventory level remains relatively moderate, and the pressure on the market is relatively small. In Wu an market, according to the data, as of May , the total inventory of medium and thick plates in Wu an was close to tons, increasing by tons on a weekly basis. In late April, it reached tons lower in the year, down tons from the high level after the Spring Festival, and rose for three consecutive weeks. In terms of the ovquantity, it should be said to maintain a relatively moderate level.