Secondly, for the replacement of hydraulic oil on the lifting platform, it is recommended to replace it every three months. If the frequency of use is not high, it can be replaced once a year. The hydraulic oil must be clean,ELFORDLEGO Electric Elevator, and after changing the hydraulic oil, maintain sufficient space, and ensure that the lifting platform can be lifted to the rated lifting height.The use of a lifting platform as a tool for storing performance blankets soft scenery, etc. In some theaters, there is a soft scenery storage lifting platform located at an appropriate location on the stage for the storage of blankets, soft scenery, etc.ELFORDConstruction electric elevators should be equipped with lower limit switches that are sensitive and reliable.Drivers of construction electric elevators should hold special construction operations and are not allowed to operate without a certificate.Pargas,Work is essential, and the main protective accessories include safety belts, guardrails,ELFORDElectric 6-meter elevator, protective covers, platforms and stairs, etc.Pipeline rupture valve: When the hydraulic system pipeline ruptures and the car stalls and descends, it can automatically cut off the oil circuit and stop descentWhen a rigid mm square or circular flat surface is applied with a normal force of N to either side of the door, the door may not meet the above requirements, but safety should be maintained.

Implementing multiple shifts of homework should fill in and submit records according to regulations.When a suspension cage with a rated load capacity acts on the buffer at a speed greater than the rated speed of .m/s the average deceleration of the suspension cage should not exceed g, and the time when the peak deceleration exceeds g should not exceedStage equipment safety door. To prevent personnel from extending their heads, hands, and feet out of the shaft and objects from falling into the vertical shaft. Its vertical position should be closed, and the height of the hoistway (hall door) should not be less than meters; The electric door opening and closing switches should be removed from the vertical and passenger compartment doors. In order to prevent accidents caused by vertical,ELFORD2 meter high electric elevator, and car roof doors not being closed.; Door interlocks should be installed on both the vertical and passenger compartment doors.Where is it,Drivers of construction electric elevators should hold special construction operations and are not allowed to operate without a certificate.Use floor doors and cage door devices on construction sites where conditions permit.When a rigid mm square or circular flat surface is applied with a normal force of N to either side of the door, the door may not meet the above requirements, but safety should be maintained.

Vertical lead screw electric lifting mechanism: Adopting a lead screw transmission method, it can achieve the lifting of a double-layer tabletop. Multiple lifting platforms can be formed as needed, and different steps can be formed within the travel range to meet the needs of meetings and performances; Pavilion, Terrace, Tower, Pavilion; Ideal props.Honest service,The scissor type electric elevator is a widely used high-altitude operation special equipment. Its scissor mechanical structure ensures high stability of the lifting platform, wide working platform, and high bearing capacity, making the high-altitude operation range wider and suitable for multiple people to work simultaneously. It makes high-altitude operation more efficient and saferThe coaxiality between the motor shaft and the worm shaft in the aluminum alloy electric elevator drive device should be less than .mm, and there should be a mm gap at the shaft end to ensure that the motor bearings bear reasonable loads and reduce motor operating noise; electricProtective measures should comply with regulatory requirements.ELFORD,Before operating the construction electric elevator, routine inspections should be carried out according to regulations and inspection records should be filled out.Setting requirements: The spacing of wall brackets along the vertical direction should comply with the provisions of the user manual.Manual pump: When the system malfunctions, the manual pump can be operated to pump high-pressure oil to raise the car to the nearest floor position