After the pipe is cleaned, the welding flux and flux shall be immediately applied to the interface and the bayonet clearance. Sufficient flux shall be thinly coated on the mating surface and assembled immediately, so that dust and dirt will not pollute the capillary gap.When placing, they should be stored separately according to the different components, and should not be mixed together. The copper surface may have electrolytes, so it will react, especially with other materials such as rubber, which has a large impact.Charlotten,Copper pipe has the characteristics of firmness and corrosion resistance, and is the choice for the installation of water pipe, heating pipe and refrigeration pipe.It is said that due to the optimistic future and tight resources, some iron plants do not take orders temporarily. The steel mills in Liaoning have increased their enthusiasm for purchasing steel. The iron mills have delivered well, and the price of raw materials has risen, so the iron price has risen. The iron mills have a high enthusiasm for producing steel, so there is not much cast iron resources, and the price has risen. A few steel mills in Tangshan began to purchase a small amount of steel for smelting, and most steel mills are still on the lookout for inquiry. Under the background of increasing cost and gradual release of demand,It can be wrapped with moisture-proof paper for moisture-proof protection. It can also prevent oxidation to a certain extent. If cracks or serious corrosion are found, they must be isolated.The price of pig iron market rose by - yuan this week, and the transaction was fair. With the increase of coke price, the cost of ductile iron in Shanxi, Henan Liaoning, Shandong and other regions has increased. In addition, with the gradual release of downstream demand, the inventory of iron plants is not large and iron plants have successively raised their prices. There are few iron foundries in Shandong, Jiangsu, Hebei and Shanxi, and the inventory remains low. As the coke price rises and the cost increases, the price of iron foundries rises again.To sum up, due to the influence of factors such as the current spot market price is much higher than the expected winter storage price of merchants, the gradual emergence of supply and demand pressure, and the weakness of raw material support, the author believes that in the short term, the spot building materials do not have the possibility to rise significantly, but with the shrinking demand, the supply and demand pressure becomes prominent However, considering the influence of winter storage and other factors, it is still possible for merchants to lower the spot price in November.

Remove the flame. If the filler metal does not melt, continue to heat the joint and try again. The melted filler metal is sucked into the casing port according to the capillary effect until a complete filler metal ring appears on the casing port. Remove the flame Pay special attention not to let the flame directly contact the filler metal. It should be the heat at the joint that melts the filler metal. In order to clean the copper pipe, the welding flux must have a degree of corrosivity, and shall be cleaned after brazing. The so-called & quot; self-cleaning& quot; fluxes are generally not recommended because of their corrosivity.Soft water is easy to cause copper pipe corrosion.If you want to make the copper surface become bright again, you can polish it with copper point solution. It can not only make the copper surface brighter, but also quickly remove the rust and oxide layer on the copper surface to restore the luster of the copper itself.manufacturer,The main force of iron ore futures closed at in The closing price of the day today was the same as that of the previous trading day, including * * * * , * * * settlement price , and position volume . The intraday tradg volume decreased by compared with the previous trading day, and the position volume decreased by compared with the previous trading day. After six consecutive days of downward adjustment, there was a rebound at the bottom of the session today, but it was corrected again later, we should properly keep the copper products we buy extend the service life of copper and ensure its performance to avoid unnecessary losses.The price of tube billets was adjusted and lowered mainly due to the production restriction of environmental protection and the weak demand for temperature and weather. Recently, the terminal demand has also shrunk due to the sudden drop in temperature,CharlottenTinned red copper bar, causing a weak shock. According to the communication with local traders in Cangzhou, various good news last week led to the shipment of thermal expansion pipes in Cangzhou in the past two weeks, which is better in the off-season, and the shipment of some specifications has improved. However, the trading atmosphere in the small and medium-sized pipe market is still cold, and the demand is slowing down gradually. To sum up, it is expected that the market price of Cangzhou seamless pipe will be stable and weak in the near future.

It is said that due to the optimistic future and tight resources, some iron plants do not take orders temporarily. The steel mills in Liaoning have increased their enthusiasm for purchasing steel. The iron mills have delivered well, and the price of raw materials has risen, so the iron price has risen. The iron mills have a high enthusiasm for producing steel, so there is not much cast iron resources, and the price has risen. A few steel mills in Tangshan began to purchase a small amount of steel for smelting, and most steel mills are still on the lookout for inquiry. Under the background of increasing cost and gradual release of demand, the pig iron market is performing well and is expected to continue to operate strongly in the short term.Safety production,For small diameter pipes, when using filler metal, the length of filler metal is allowed to be equal to the diameter of the pipe, which is enough to fill the weld crater. One of the five major application fields of red coppr plate T red copper bar and red copper tube: copper is the most widely used and used in the electrical and electronic industries, accounting for more than half of the total consumption. Used for various cables and wires, motors and transformers, switches and printed circuit boards; In the manufacture of machinery and transport vehicles, it is used to manufacture industrial valves and accessories, instruments, sliding bearings, molds, heat exchangers, pumps, etc.Dissolved oxygen in water is a major factor in copper pipe corrosion.So far as the storage method of copper materials is concerned, we should properly keep the copper products we buy, extend the service life of copper and ensure its performance to avoid unnecessary losses.Charlotten,It can be wrapped with moisture-proof paper for moisture-proof protection. It can also prevent oxidation to a certain extent. If cracks or serious corrosion are found,Charlotten7075 aluminum pipe, they must be isolated.After : on October , continue to implement the measures of stopping and limiting production specified in TZBZ [] No. document. All sintering machines and shaft furnaces using wet desulphurization in iron and steel enterprises in the city were shut down, coking, electric power, cement, chemical and other key vehicle enterprises are not allowed to transport vehicles into and out of the plant. After : on October , the vehicle enterprises in the above industries will implement % of the peak load shifting emission reduction measures. It is estimated that the average daily consumption of sintering powder in Tangshan will be more than yuan, and the purchase of iron ore may still maintain a small amount of prudence. In addition, due to the influence of industrial users & amp; quot; coal to gas& quot;, the recent performance of coke is weak. Therefore, in terms of steel plant production, the support of raw materials is weak.The blowing mouth of the welding tool should not be too small to avoid excessive concentration of heat.