Lifting and loweringCheck the smooth steel wire rope and various fasteners, if there is excessive wear,Power supply voltage: Motor power: Lifting: Rocker self reset switch operation Overload protection: Over current relay.Monthly maintenance: View weekly inspection itemsHeidelberg,Check the protective cable condition of the cable guide frameThe lifting stage can provide real-time information on the operation of the entire vehicle, avoiding relying solely on the experience of operators to coordinate with each other, and improving the reliability and safety of the system. The definition of safety zone is very important because the lifting stage has a large range of movements and it must be accurately calculated. The lifting stage has two structurally separate systems,IrelandAluminum alloy hydraulic lifting platform, the ground turntable and the high-altitude work bar. However, for various movements on the vehicle, it is also an interconnected system, which needs to consider the priority of operation, system redundancy, and safety assurance of actions.Check the smooth steel wire rope and various fasteners, if there is excessive wear, it is necessary to replace them

　　?? When the construction supervisory department fulfills its safety supervision and inspection responsibilities, it shall order the immediate elimination of potential safety hazards in the production of construction elevators and cargo elevators discovered during the inspection. If safety cannot be guaranteed before or during the elimination of major production safety hazards, it shall be ordered to evacuate workers from the hazardous area or temporarily stop construction. In the work of hazard investigation and control, the investigation shall be serious, the rectification shall be resolute, and the results shall be consolidated.Drivers should be responsible for supervising the uniform distribution of items transported by the platform on the platform as much as possible to prevent partial loading and prohibit overloading. Platform does not allowOrganize, remove rust and repaint the structural components such as the suspension cage and guide rail frame for corrosion,IrelandSelf propelled mobile lifting platform, and reinforce the severely corroded load-bearing membersmarket price,Drop test to check if the braking interval of the safety governor meets the requirements of the rules. Equipment transfer maintenance: Check the coupling between the electric motor and the worm gear reducer, and dismantle the gearbox. Clean all components and seals, replace excessively worn and deformed parts and smooth oilThe reduction gearbox, gearbox, external meshing gear and other parts as well as the hydraulic oil, are all carried out according to the requirements in the table.Lifting and lowering

Regarding the construction elevator with counterweight, the crown wheel, and the counterweight steel wire rope bracketHonest service,Please refer to the instruction manual for the maintenance and maintenance of the elevator to check the braking torque of the brakeThe driver shall close and lock the movable doors at both ends of the protective fence before work, and then ring the bell to start. It is strictly prohibited to work with the movable doors of the protective fence open. In case of special circumstances during platform operation, the emergency stop switch can be used to stop the platform. However, during normal operation, correct or replace with new partsIreland,Check the interlocking equipment, up and down travel, and other safety maintenance switches of the cage door and fence doorAdjust and correct various safety doors and mechanical interlocking equipmentClean and inspect the crown wheel frame assembly, correct or replace with new parts