Double layer steel mesh: The diameter of the steel bars is mm, with a spacing of mm.The angle between the wall bracket and the horizontal plane should comply with the requirements of the user manual.Hejian,If the set screw is loose, be sure to pin it tightly to prevent accidents caused by the shaft pin falling off. Hydraulic oil should be kept clean and replaced every months.The function of the lifting platform in a theater is roughly as follows: the main lifting platform arranged in the main performance area of the stage is mainly used to quickly change the scenery. Typically,HejianTurkwan, with&quo; Product; In the music and dance theater stage arranged in a zigzag pattern, the lifting platform, side car platform, and rear car turntable perform a rapid transformation of the entire or partial scene. This arrangement allows for rapid switching of three full sets.Fariskur, effective protective measures should be taken.Setting requirements: For construction electric elevators that operate in multiple shifts,HejianSan Jose, the handover system should be implemented, the manual pump can be operated to pump high-pressure oil to raise the car to the nearest floor positionThe suspension cage movement can only be resumed after operator operation.The oil cylinder and sealing components are made of imported components to solve the problem of unstable oil pressure and oil leakage of components for customers.Product surveyWhen the landing door is closed, the full width of the lifting passage opening should be covered.Installation verticality deviation guide rail frame erection height, h/mH≤ H& gt; verticality deviation/mm≤ (/h≤ ≤ ≤ ≤ pairs of steel wire rope construction electric elevators, the verticality deviation of the guide rail frame should not exceed (/) h.In addition to ground protective fences, low level doors can be used. Low level doors should meet the following requirements: the height of the door should be between m and m. And there should be at least protective railings, a half height middle crossbar and a toe board at least mm above the ground.

Especially suitable for steel structured factories, suitable for both indoor and outdoor installation.Focus on Development,Electric elevators used in various places.Do not move after lifting, and do not lift until the four legs are firmly supported.When the foundation is set on the roof or floor structure, the bearing capacity of its supporting structure should be checked.Hejian,Setting requirements: The installation and dismantling workers, electricians, and other operators of construction electric elevators should have special construction operations.Then,HejianExposed Cow, the lifting platform platform platform that carries the load needs to be balanced, and no deviation of one side is allowed. The lifting of goods does not allow people to stand on both sides of the platform, and the lifting of goods should try to maintain a stable and uniform speed.When a rigid mm square or circular flat surface is applied with a normal force of N to either side of the door, the door may not meet the above requirements, but safety should be maintained.