The structure of the submersible slurry pump will be more intuitive. First, the equipment will use centrifugal force to drive the liquid from the impeller to the outer edge and obtain energy, and then leave the edge of the impeller at a higher speed　　What is the solution to this situation?Kirkuk,　　Then start the spray pump. It is specially used for control equipment such as fire fighting, sprinkler and water curtain in high-rise and low-rise industrial and civil buildings. It is also suitable for restaurants, stores, warehouses, underground garages and other places. The ordinary sprinkler head can be directly installed or hung on the sprinkler pipe network　　 Then tighten the compression nut on the packing gland evenly to make the liquid leak out in drops, and pay attention to the temperature rise outside the packing chamber.Blagoveshchensk , because there will be some difference between the marked head when using and the head when using. This is because the pipe itself　　Superior,KirkukISG single stage vertical pipeline pump, complete protection s, reasonable structure, convenient installation and high cost performance. In case of sudden power failure of the plant and emergency, the water pump will automatically start to supplement the pipe network pressure.　　It will burn out. If there is a heating problem in use, you can refer to the following reasons.

　　 Next, the water seal,KirkukVertical heavy-duty slurry pump, lock ring and other parts need to be installed.　　Consider the vertical separation level of the tail equipment.　　Moreover, explosive and toxic liquid will cause fire, explosion and poisoning and the consequences will be unimaginable.Marketing Department,　　The seal cannot bear the water pressure at this depth. Once the water leaks, the motor will not work normally, resulting in damage to the submersible slurry pump. The biggest difference between the submersible slurry pump and the horizontal slurry pump and the vertical slurry pump is that the motor of the submersible slurry pump and the shaft connected to the pump are integrated and sealed Closed.　　The high-pressure water flows to the space occupied by the original bubble at a very high speed, keep a small amount of cleaning water flowing along the shaft, regularly adjust the packing gland, check the packing and regularly replace the packing. The shaft seal water pressure and water volume shall meet the above (shaft seal inspection) requirements.

　　 install the front pump shaft first and then the rear bearing for the slurry pump of the filter press of the cylindrical bearing box.Quality assurance,　　When using the sand pump, be sure to pay attention to the steering divergence between the motor and the pump. The sand pump has an arrow on the pump to mark the main steering. After the power supply is connected, run the pump without load. Check whether the motor operates normally. During operation, be careful not to exceed the bearing on the pump support to avoid　　The waste water and dirt of conveying belt particles in factories, steel mills, power plants coal processing industries, drainage systems of urban sewage treatment plants municipal engineering, construction sites and other industries can also be used to pump clean water and corrosive media.　　After the submersible slurry pump adds a water gun to the support at the bottom of the submersible slurry pump, the hardened mud layer around the slurry pump will collapse rapidly under the applied water pressure, which will also increase the sand pumping area. This will also increase the sand pumping area,KirkukHH slurry pump, so there will be no buried pump when it is used. However,Kirkuk,　　Many users, including new practitioners of slurry pumps, often fail to distinguish the difference between submerged vertical slurry pumps and submerged slurry pumps. The names of submerged and submerged slurry pumps seem similar, but there are essential differences. What is the difference between submersible slurry pump and vertical slurry pump?　　The other mechanical seal is a split seal, which can be replaced without disassembling the slurry pump.　　Generally, the diving depth of the submersible slurry pump is not more than meters, and the operation is reliable. Why not more than meters? This is the crucial technical point of the submersible slurry pump, because the current sealing technology in China is more than meters, not because the slurry pump has a problem, but because