MuktagachaQJ submersible pump,

　　Function of shaft seal of submersible slurry pump: the main of shaft seal is to prevent high-pressure liquid from leaking out of the pump and prevent air from entering the pump.　　With water,　　The structural characteristics are described respectively.　　During the process, the equipment must be regularly maintained and overhauled to avoid blockage. As the name suggests, the water pump is mainly used to transport water when it is used. The effect of normal pumps is often better when it is used, but in fact, we use it at ordinary timesAnak,　　Balance of.　　If the oil seal ring of the shaft is seriously worn, replace it with a new one.　　This phenomenon shows that the failure of the pump is not only a material problem but also reminds the pump designers and producers that in addition to good working conditions, the pump should also have good corrosion resistance, high reliability and long service life. The pump shall be designed in addition to the conventional design method of fluid mechanics

　　 selection of flow: single suction pump or double suction pump shall be selected according to the flow; single suction pump or multi suction pump shall be selected according to the lift.　　Easy installation and disassembly.　　All kinds of newly designed mechanical seals of submersible slurry pumps contribute greatly to the growth of market share.analysis,　　As an emerging product, the submersible slurry pump has many advantages, especially filling the gap in the application conditions of the traditional horizontal and vertical slurry pumps. At present, the application of the submersible slurry pump is gradually becoming more and more widespread, and the market recognition is continuously improving, especially meeting the needs of deep-water sand pumping and dredging. At present, the depth can reach meters.　　In the mud pump, the axial force is mainly composed of the pressure difference force of the liquid effect on the impeller and the gravity of the whole rolling part. The effect direction of the two forces is the same, and the resultant force is the sum of the two forces. If the submersible slurry pump is equipped with an auxiliary impeller, the liquid effect is on the auxiliary impeller　　 If the pump is equipped with a vacuum gauge or pressure gauge,MuktagachaSewage pump diving, close the cock connected with the submersible slurry pump before starting the motor, and then gradually open the outlet sluice valve. If the flow is too large, you can properly turn down the gate valve for adjustment. Otherwise, if the flow is too small,Open the gate valve.

　　The slurry pump of underground pump can also work normally.details　　 Pipeline layout: Firmly support the water pipe and drain pipe to prevent the force of the pipe from acting on the submersible slurry pump.　　The sewage pump will leak. If the water pipe leaks, it will reduce the power of the water pump and even damage the sewage pump. In case of fixed installation,MuktagachaSubmersible slurry pump, it shall be applied on the pipe to avoid leakage. Pages can be welded by electric welding, buried in the soil, coated with asphalt, and then should not be gassed. Steaming of tap water products　　Be sure to choose a pump that is more suitable for use.Muktagacha,　　 Another possibility is that the gas is sucked in when the pump is in use.　　The installation of submersible slurry pump is a step that needs to be concerned. Since we all care about it, it is mainly because the installation will directly affect the use effect. The installation work should be seamless. Some key operating points can be seen when installing the slurry pump.　　It can also be used for cooling and lubrication. Once the temperature in the water pump is too high, the pump shall be stopped immediately for maintenance. Otherwise, the excessive temperature will not only affect the wear of small parts inside the equipment, but also seriously affect the working efficiency of the equipment. So what is the reason for the high temperature of the equipment