The installation of submersible slurry pump is a step that needs to be concerned. Since we all care about it, it is mainly because the installation will directly affect the use effect. The installation work should be seamless. Some key operating points can be seen when installing the slurry pump.　　The above is a brief introduction to the effect and form of shaft seal of submersible slurry pump. Users can choose the appropriate shaft seal type according to their actual needs.Pontianak, the discharge valve must be opened to start the self-priming pump, so that the gas can be discharged from the discharge port. Secondly, there should be enough liquid in the cavity of the self-priming pump, otherwise it will not　　 Then reinstall the equipment on the engine and install the rubber hose.Villa Mercedes,　　When using the sand pump, be sure to pay attention to the steering divergence between the motor and the pump. The sand pump has an arrow on the pump to mark the main steering. After the power supply is connected,PontianakPipeline pump, run the pump without load. Check whether the motor operates normally. During operation,PontianakLong shaft submerged slurry pump, be careful not to exceed the bearing on the pump support to avoid　　If the pump outputs more medium liquid, it will certainly do more work. If it sends less water, it will certainly do less work, and the current will be correspondingly reduced. Pump power (kw) = head (m) × Flow (m/s) × The gravity of the fluid (kg/m for water) divided by (power conversion factor) divided by the efficiency of the pump (about　　 install the front pump shaft first and then the rear bearing for the slurry pump of the filter press of the cylindrical bearing box.

　　In fact when the submersible slurry pump is blocked during use, it will not only have a certain impact on the working efficiency of the equipment during operation, but also cause serious damage to the equipment itself, the hardened mud layer around the slurry pump will collapse rapidly under the applied water pressure, which will also increase the sand pumping area. This will also increase the sand pumping area, so there will be no buried pump when it is used. However,original,　　Be sure to choose a pump that is more suitable for use.　　Vertical slurry pump is an early product. Submersible slurry pump is a new product developed with the improvement of social demand and operating environment.　　The type selection design of submersible slurry pump has a great impact on the service life and operation stability of slurry pump. A scientific and reasonable model selection design will affect whether your slurry pump can achieve the best efficient operation.

　　It is not correct that it has no effect on us.Safety and health,　　It is located in the middle, so it seems that many regions have good effects when using it.　　At this time it is necessary to use the fire control cabinet. The fire control cabinet can control multiple water pumps to ensure the normal operation of the fire pumps.　　Work, no noise and vibration,PontianakSubmersible slurry pump, and the site is cleaner.Pontianak,　　Whether it is the pre installation inspection or the post installation commissioning inspection, the correct operating procedures must be strictly followed. Only the correct operating steps can make the product play an effective role in the use site.　　 Dust and oil stains on the motor reduce the heat dissipation capacity of the equipment and cause the equipment temperature to rise.　　 Moreover, the processes of these two pumps are also different, and the sewage pump can generally be adjusted. Submersible pumps are generally used in some special or other places.