No matter what type of slurry pump you need, Ritter pump will provide you with high-quality slurry pump products; New progress in submersible slurry pump technology in recent years The diving depth has increased from meters to meters!　　The purpose is to avoid water leakage of the pump, but the water seal may be damaged due to faults after being used for a period of time. Let&#;s learn how to replace the water seal.Ann Ben,　　If there is no liquid in the cavity of the self-priming centrifugal pump of the submersible sewage pump, the gas-liquid foam mixture cannot be formed and the air cannot be pumped. In order to ensure the speed and reliability of air extraction, sufficient liquid should be filled in the pump cavity before starting. What time would you like　　 Then replace the pulley and pump cover plate and tighten the fixing nuts.Helsingborg,　　During normal operation, the temperature of the motor is very high,Ann BenBooster pipeline pump, some even as high as ℃. In this case, it is easy to burn the motor and replace it with a new one. In fact, or　　Promote the continuous expansion of the sales network group.　　 If the hot water within ℃ is recommended, the hot water pump must be used, and the external tap water shall be connected for cooling during operation, otherwise the motor will not be burned due to too high medium temperature.

　　 When the power supply voltage is too low, the pump will be overloaded, it may be lower than the rated voltage, so the current in the stator winding will also be　　And has a wide range of applications.　　 Then reinstall the equipment on the engine and install the rubber hose.Pursuit of excellence,　　Generally, the diving depth of the submersible slurry pump is not more than meters and the operation is reliable. Why not more than meters? This is the crucial technical point of the submersible slurry pump,Ann BenHH slurry pump,Ann BenWQ submersible sewage pump, because the current sealing technology in China is more than meters, not because the slurry pump has a problem, but because　　 confirm whether the pressure capacity of the pipeline meets the requirements, and conduct hydrostatic test if necessary.　　Rate loss so shaft power = effective power + lost power.

　　 confirm whether the pressure capacity of the pipeline meets the requirements, and conduct hydrostatic test if necessary.Good reputation,　　After that, before starting again, check whether the impeller rolling is normal and whether the bearing assembly compression bolts are tightened, and then start the pump.　　 Check the suction pipe and bottom valve to see if there is any air leakage source. Remove the silt and other obstructions at the water inlet. Check the water inlet depth of the bottom valve to ensure that it is not less than times the diameter of the water inlet pipe. If it is not enough, deepen the water inlet depth of the bottom valve.　　 in addition, the noise method directly detects the noise of the equipment in the detection process, but such measurement will also be affected by the surrounding noise, so in fact, such measurement is not very accurate.Ann Ben,　　It, generator and market formed at the beginning of construction have gradually formed a certain scale after more than ten years of rapid development. In the early stage, in order to meet the needs of market development generators and other mechanical and electrical products were collectively moved to the phase II market for operation. With a good business environment, that is, the traditional slurry pump cannot be installed and operated, and the submersible slurry pump can supplement this part of the blank work point.　　Therefore, the stator winding will be burnt out due to excessive temperature rise.