Then unscrew the nut at the front end of the pump shaft remove the cover plate, and press out the middle impeller and water seal.　　 Cutting blades can be selected to cut some large block solid substances into pieces during use, so that blockage can be avoided during reuse.Bamiyan,BamiyanScrew deep well pump,　　The deep well pump works underwater. Taking Hengsheng deep well pump as an example, the application market is also larger. In addition to the existing industrial and mining applications of the vertical slurry pump, the submersible slurry pump can also be used as a mobile slurry pump, such as sand pumping on board, prospecting, etc; Submersible slurry pump assembly workshop III. what are the advantages of submersible slurry pumpRobertsport,　　Rate.　　 Next, it is necessary to check the water seal. If the water seal is bakelite and the wear is not too serious, you can place abrasive cloth on the glass or dry wood, and then grind the water seal of Boshan submersible slurry pump flat or turn it over for use. However, if the thrust rubber water seal is used, when　　It can improve the mechanical efficiency to a certain extent. Moreover, the molecular structure of the coating itself has good compactness, which can well isolate the air, water and other media from the pump impeller during use, in the market, for example, the sweeping pump, some of which have a depth of more than meters, it is not suitable to use a vertical slurry pump under such a working condition, but it is extremely easy to use a submersible slurry pump.　　I would like to talk with you about the problems that should be paid attention to when using deep well pumps.　　 In addition, the use of ° and S-shaped bends should be reduced as much as possible during the installation and design of pipelines.resources,　　Stability and reliability of seals between pump bodies.　　Pump sewage submersible pump and seawater submersible pump.　　 for screws that are too tight or rusted for a long time, the nut can be lubricated with kerosene prepared in advance,BamiyanWQ submersible pump parameters, or the nut can be gently knocked with a wooden hammer and then removed. This method can also be used in slurry pumps and other places.

　　With the continuous development of slurry pump technology,BamiyanWater well pipeline pump, submersible slurry pump has also responded to the market demand. At the same time, this type of pump is especially suitable for the depth where the vertical slurry pump cannot operate. Pay attention when using the equipment. The submersible slurry pump can operate if its depth is less than m, but it exceedsCreate brilliance,　　 Then tighten the compression nut on the packing gland evenly to make the liquid leak out in drops, and pay attention to the temperature rise outside the packing chamber.　　 With protection . cf fire control cabinet integrates many electrical components, which can form a three-dimensional protection for the fire pump, including voltage overvoltage and undervoltage protection, current overcurrent and undercurrent protection, phase loss protection, overheating protection, etc. this　　If the shaft seal is not properly selected, it will not only require frequent maintenance during operation, but also leak a large amount of transmitted liquid.Bamiyan,　　At present, mechanical seals occupy an increasing share in the slurry pump seal market.　　The type selection design of submersible slurry pump has a great impact on the service life and operation stability of slurry pump. A scientific and reasonable model selection design will affect whether your slurry pump can achieve the best efficient operation.　　Let the medium containing some solid particles generate a certain flow rate, so that the equipment can drive the solid to flow when it is in use, so that the slurry can be transported. In terms of the principle of the submersible slurry pump it is actually quite simple