It is mainly used to manufacture electrical devices such as generators, buses, cables, switchgear, transformers, and thermal conductive devices such as flat plate collectors for heat exchangers, and solar heating equipment. Common copper alloys are divided into three categories: brass, bronze and white copper. Pure copper plate is a purplish red metal, commonly known as & quot; copper plate& quot;, & amp; quot; red copper plate& quot; or & quot; red copper plate& quot;.Remove the flame. If the filler metal does not melt, continue to heat the joint and try again. The melted filler metal is sucked into the casing port according to the capillary effect until a complete filler metal ring appears on the casing port. Remove the flame Pay special attention not to let the flame directly contact the filler metal. It should be the heat at the joint that melts the filler metal. In order to clean the copper pipe, the welding flux must have a degree of corrosivity, and shall be cleaned after brazing. The so-called & quot; self-cleaning& quot; fluxes are generally not recommended because of their corrosivity.Nahongsitamarat,Many people do not fully understand the storage method of copper tubes in the process of use and production methods.Safe and reliable: copper pipe combines the advantages of metal pipe and non-metal pipe. It is harder than plastic pipes and has the high strength of ordinary metals (the strength of cold drawn copper pipes is equivalent to that of steel pipes with the same waess); It is also easier to bend than ordinary metals, has good toughness and high ductility, and has excellent anti vibration, anti impact and anti frost expansion properties.Tokmok,In consideration of the above factors, more and more steel plants have stopped production since October, and the production limit in Wu an and Tangshan heating seasons has been advanced. In addition, the formal implementation of production limit in & quot; +& quot; urban heating seasons after November by steel enterprises, the demand for iron ore in the future is likely to further deteriorate. The iron ore inventory of the steel plant is relatively high, and the willingness to further replenish the inventory is not strong. In terms of supply, the fourth quarter is generally the peak period for the shipment of imported ores. Although the production of domestic mines has been reduced due to environmental protection, the quantity of * * * is relatively limited. In general, the terminal demand has also shrunk due to the sudden drop in temperature, causing a weak shock. According to the communication with local traders in Cangzhou, which is better in the off-season, and the shipment of some specifications has improved. However, the trading atmosphere in the small and medium-sized pipe market is still cold, and the demand is slowing down gradually. To sum up, it is expected that the market price of Cangzhou seamless pipe will be stable and weak in the near future.The hard copper tube is not artificially treated after being drawn or extruded, so that it can be naturally formed. At this time, the organizational form in the copper tube is full. This kind of copper tube is more likely to crack and is not suitable for bending. Therefore, the hard copper tube is generally straight.

Copper tube is also called copper tube nonferrous metal tube. It is a pressed and drawn seamless pipe, characterized by light weight, good thermal conductivity, high low-temperature strength and corrosion resistance. Because of these excellent properties of copper tubes, the use of copper tubes is very common. What are the differences between hard copper tubes and soft copper tubes in the use process? What are the differences between the two in terms of specific applications?Re treat the water quality.The hard copper tube is not artificially treated after being drawn or extruded, the organizational form in the copper tube is full. This kind of copper tube is more likely to crack and is not suitable for bending. Therefore, the hard copper tube is generally straight.Total quality management,On October , according to the Economic and Information Commission oong Province, at the end of September , Shandong Province had resolved the overcapacity of million tons of pig iron and million tons of crude steel, and all the de capacity equipment had been shut down and withdrawn. On October the Development and Reform Commission of Handan City released the Plan for Handan City to Eliminate Excess Iron and Steel Capacity. Statistics show that the iron making capacity of Handan in was million tons and the steel making capacity was million tons.It is mainly used to manufacture electrical devices such as generators, buses, cables, switchgear, transformers, and thermal conductive devices such as flat plate collectors for heat exchangers, pipes,Nahongsitamaratbrass tube, and solar heating equipment. Common copper alloys are divided into three categories: brass, bronze and white copper. Pure copper plate is a purplish red metal, commonly known as & quot; copper plate& quot;, & amp; quot; red copper plate& quot; or & quot; red copper plate& quot;.Red copper inventory in key areas has risen continuously, but the total pressure is not big. From the current overall inventory situation of the main distribution centers Wu an, Jiangyin and Lecong, the inventory level remains relatively moderate, and the pressure on the market is relatively small. In Wu an market, according to the data, as of May , the total inventory of medium and thick plates in Wu an was close to tons, increasing by tons on a weekly basis. In late April, it reached tons lower in the year, and rose for three consecutive weeks. In terms of the ovquantity, it should be said to maintain a relatively moderate level.

The price of pig iron market rose by - yuan this week, and the transaction was fair. With the increase of coke price, the cost of ductile iron in Shanxi, Henan, Liaoning, Shandong and other regions has increased. In addition, with the gradual release of downstream demand the inventory of iron plants is not large, and iron plants have successively raised their prices. There are few iron foundries in Shandong, Jiangsu, Hebei and Shanxi, and the inventory remains low. As the coke price rises and the cost increases, the price of iron foundries rises again.system,In addition, the evaporation amount of zinc is as high as % during shielded metal arc welding. A large amount of zinc evaporation leads to the decline of mechanical properties and corrosion resistance of welded joints so copper pipes need to be selected for many times in other places.Under the action of high welding temperature, and also increases the sensitivity to stress corrosion.The blowing mouth of the welding tool should not be too small to avoid excessive concentration of heat.Nahongsitamarat,Nahongsitamarat310s stainless steel plate,The main force of iron ore futures closed at in The closing price of the day today was the same as that of the previous trading day, including * * * * , * * * , settlement price , trading volume , and position volume . The intraday tradg volume decreased by compared with the previous trading day and the position volume decreased by compared with the previous trading day. After six consecutive days of downward adjustment, but it was corrected again later there was a rebound at the bottom of the session today, and the closing was flat.However, it is difficult to change this situation too much in the short term. It is expected that the domestic strip steel price will mainly rise in the short term. It is reported that in order to pursue profits, Tangshan Iron and Steel Group Co., Ltd. is currently increasing the supply of hot coils. It does not rule out that more steel mills in the future are inclined to one end of the plate in pursuit of profits, or to lay hidden dangers for the decline. As far as tomorrow is concerned, the price may still maintain a narrow range of shock operation pattern.In the middle and late ten days, although there were good news such as the rise of futures and the increase of production restriction policy in Wu an region, due to the high inventory level, traders had no desire to increase prices, most of them had shipped goods and spot prices lacked motivation to rise. The market inventory rose significantly. At that time, the market inventory in Handan reached a high level after the festival. The sluggish demand performance for a long time led to the oversupply of the market, and the continuous rise of inventory led to the empty market mentality.