On October , according to the Economic and Information Commission oong Province, at the end of September , Shandong Province had resolved the overcapacity of million tons of pig iron and million tons of crude steel, and all the de capacity equipment had been shut down and withdrawn. On October , the Development and Reform Commission of Handan City released the Plan for Handan City to Eliminate Excess Iron and Steel Capacity. Statistics show that the iron making capacity of Handan in was million tons and the steel making capacity was million tons.Copper tube is also called copper tube nonferrous metal tube. It is a pressed and drawn seamless pipe characterized by light weight, good thermal conductivity, high low-temperature strength and corrosion resistance. Because of these excellent properties of copper tubes, the use of copper tubes is very common. What are the differences between hard copper tubes and soft copper tubes in the use process? What are the differences between the two in terms of specific applications?Karina,As the copper pipe is easy to process and connect,Karina316L stainless steel plate, it can save materials and total cost, stability and reliability, and can save maintenance during installation.Let s elaborate on the advantages of copper pipe materials: copper pipe floor heating refers to a heating method that uses hot water as the thermal medium, circulates in the copper pipe heating pipe, heats the floor, and heats the floor through the ground in the form of radiation and convection heat transfer. I. The copper tube has fast heat dissipation effect and strong heat resistance. Even under the condition of high temperature water supply, the service life of the floor heating tube will not be affected. Two. Copper pipe is a metal pipeo it is not easy to scratch. Therefore, it is not easy to leak. Three. High temperature resistance, high pressure resistance, relative to any ordinary plastic pipe. Copper tube floor is warm and resistant to high temperature and pressure. Four. Long service life. Five.Nea Filadhelfia,The composite method of three production methods of copper tube is also a high-tech production method for this method. It is a copper material containing impurities. Those copper materials, and then the material is purified to produce copper tube materials.Advantages: good quality, fine structure, high density high pressure resistance, large bending deformation, suitable for frequent cold and heat exchange, large temperature difference in working environment, and large size copper tube can be produced.In the first ten days of May, the overall order intake of medium and heavy plate mills in Tianjin Hebei Henan region in the first ten days of May remained stable and weak. Due to the weak market shock the overall order intake of the spot steel market was relatively weak. The total quantity of orders received in the first ten days of May is only about tons, while at the end of April, the total quantity of post settlement agreements of main steel plants can exceed tons.

The price of tube billets was adjusted and lowered mainly due to the production restriction of environmental protection and the weak demand for temperature and weather. Recently, the terminal demand has also shrunk due to the sudden drop in temperature, causing a weak shock. According to the communication with local traders in Cangzhou, various good news last week led to the shipment of thermal expansion pipes in Cangzhou in the past two weeks, which is better in the off-season, and the shipment of some specifications has improved. However, the trading atmosphere in the small and medium-sized pipe market is still cold, and the demand is slowing down gradually. To sum up, it is expected that the market price of Cangzhou seamless pipe will be stable and weak in the near future.ased copper tube is made of oxygen free copper rod, which has good processing characteristics and can be punched, bent and other process design requirements. The surface can be subject to anti-corrosion treatment, such as nickel plating, tin plating, zinc plating, etc. The surface anti-corrosion can reach hours of fog test. The surface tin plating is environment-friendly lead-free tin, and the surface tin layer supports soldering. T degreased copper tube is mainly used for communication cabinet, transformer, charging pile, box type substation and other electrical facilities. The copper bar is harder than the plastic pipe and has the degree of common metal (the strength of the cold drawn degreased copper pipe is equivalent to that of the steel pipe with the same wall thickness). It is not easy to corrode and is resistant to high temperature and high pressure. It can be used in various applications. The main material of copper bar is copper. The melting point of copper is as high as ℃, and the temperature of hot water can be ignored for degreased copper pipe, so as long as it is used correctly, there is no need to worry about safety. When choosing to decorate the house, few people ask about the water supply pipe of the house. In fact, the material of water supply pipeline will greatly affect people s health. T copper tube has strong capacity. Escherichia coli in the water supply will not continue to breed in the degreased copper tube, and more than % of the water will disappear after entering the degreased copper tube for hours. This biological characteristic is that there is a small amount of copper ions dissolved in water in the degreased copper tube, and copper ions have a strong ability. Copper and zinc plating can avoid rusting and show a zinc protective film to metal materials. The conductive metal material repair and color enhancement care agent I can generate the thickness of the metal material epoxy protection layer and the pipelincathodic protection layer, which can resist extreme weather and is suitable for the long-term surface of metal materials. The actual effect of salt and water corrosion resistance is good. The copper bar tin plating can prevent the air oxidation of the copper bar and the connection surface of the copper bar. In addition, the melting of metal tin and copper will produce aluminum alloy, which will improve the adhesion of copper strip coating. In addition, the conductivity of metal tin is good. The purpose of copper and tin plating: effectively prevent copper from becoming verdant due to moisture, and also prevent copper from oxidizing/sulfurizing and blackening and affecting electricity. The service life of the tinned copper tube is several times or even more than ten times, which greatly increases the service life of the copper and plays a considerable role in protecting the copper. The of tinned metal surface treatment on copper bar is to avoid air oxidation. As the air in industrial production air, marine climate or cold air is easy to turn black or produce copper green when oxidized, the copper bar surface shall be tinned for the total area, the resistance and conductivity of the steel bar lap surface.With the continuous development of industry, the demand for plastic coated copper tubes is gradually increasing. Then how to apply wood grain paint on alloy pipes. Wood like paint is a kind of wood like paint. It is used for spraying plastic coated copper pipe and its process flow. Plastic coated copper pipe is mainly used to manufacture high-pressure alloy pipe for heating surface of water tube boiler with high pressure and above. In the morning market the mainstream spot price quoted by Lianzhong was - yuan/ton, and the tax inclusive base price quoted by Hongwang and Chengde was - yuan/ton. On a month on month basis, part of the producing areas recalled yuan, and the mainstream tax inclusive base price in the market changed from strongeak in the - plastic coated copper pipe supply and demand relationship. It was difficult for the price of plastic coated copper pipe in the Guangzhou market to fall sharply this week. Second, plastic coated copper tubes are widely used in superheaters, headers and main steam ducts of domestic HP, UHP and subcritical power plant boilers. Third,Karina6063 aluminum tube,KarinaCopper clad aluminum bar, large diameter pipes are mainly used as headers and main steam pipes with steam parameters below ℃.Insert the pipe into the top of the bayonet,e the sleeve on the pipe to evenly apply the flux on the joint, and confirm that the pipe is inserted into the bottom of the socket, then wipe off the excess flux, and the joint is assembled and can be heated.Customer first,Today, the price of tube billets is up and down. At present, Jiangxin hot rolling is yuan, continuous casting yuan is down yuan, Dongfang hot rolling yuan is down yuan, Luli hot rolling yuan is down yuan, Tiangang hot rolling an is down yuan, production is stopped in mid January, Weigang hot rolling yuan is up yuan, continuous casting yuan is up yuan, Huaigang yuan is up yuan, Zhongtian yuan, Changqiang yuan, Linggang yuan.At the opening this morning the market price of Zhengzhou copper bar was basically stable. According to the monitoring data of the Lange cloud business platform, the same below), the * mm copper bar was yuan, and the * mm copper bar Henan copper bar was yuan.Red copper inventory in key areas has risen continuously, but the total pressure is not big. From the current overall inventory situation of the main distribution centers Wu an, Jiangyin and Lecong, the inventory level remains relatively moderate, and the pressure on the market is relatively small. In Wu an market, according to the data, as of May , the total inventory of medium and thick plates in Wu an was close to tons, increasing by tons on a weekly basis. In late April, it should be said to maintain a relatively moderate level.

In the first ten days of May, the overall order receiving quantity of Tianjin Hebei Henan Plate Plant was not ideal. According to the monitoring data, the overall order intake of medium and heavy plate mills in Tianjin Hebei Henan region in the first ten days of May remained stable and weak. Due to the weak market shock, the overall order intake of the spot steel market was relatively weak. The total quantity of orders received in the first ten days of May is only about tons, while at the end of April, the total quantity of post settlement agreements of main steel plants can exceed tons.Quality documents,First of all, we should set up a warehouse. The temperature in the warehouse should be generally kept at - ° C, while the humidity should be normal. The room should be kept ventilated.Advantages: low investment cost, low production cost, high output and low price.To sum up, due to the influence of factors such as the current spot market price is much higher than the expected winter storage price of merchants, the gradual emergence of supply and demand pressure, among which the contraction of market demand has a greater impact. Therefore the author believes that in the short term, the spot building materials do not have the possibility to rise significantly, and the price of building materials may mainly operate in shock, but with the shrinking demand, the supply and demand pressure becomes prominent, However, considering the influence of winter storage and other factors, it is still possible for merchants to lower the spot price in November.Karina,However, it is difficult to change this situation too much in the short term. It is expected that the domestic strip steel price will mainly rise in the short term. It is reported that in order to pursue profits Tangshan Iron and Steel Group Co., Ltd. is currently increasing the supply of hot coils. It does not rule out that more steel mills in the future are inclined to one end of the plate in pursuit of profits, or to lay hidden dangers for the decline. As far as tomorrow is concerned, the price may still maintain a narrow range of shock operation pattern.In Jiangyin market, another distribution center, slightly lower than the normal level. At the beginning of this week, the price gap between Jiangyin prices and those in the north has also been able to correspond to the slightly lower circulation inventory. However, from the perspective of the policy port of the steel plant, the overall production situation of Nangang, Hengrun, Dada, etc. is relatively normal, and the amount of resources in the later period remains stable. The overall inventory of Lecong market remains at about to tons, which is a medium normal level, and the recent spot price of Lecong market has a large gap with that of the north.[] Welding process of copper pipe Clean the end and seven ports of steel pipe with steel wool. Do not use abrasive cloth or abrasive paper to clean, because it will affect the clean interface and result in poor welding effect.