Setting requirements: The installation and dismantling workers, with a size of meters by meters.Swarth and other operators of construction electric elevators should have special construction operations.The safety bulletin board for construction electric elevators should be hung at the protective shed of the electric elevator,When a suspension cage with a rated load capacity acts on the buffer at a speed greater than the rated speed of .m/s, the average deceleration of the suspension cage should not exceed g, and the top floor height can be installed at least . meters.Beograd,The foundation production and acceptance of electric elevators for foundation construction should comply with the user manual and regulatory requirements.Construction electric elevators should be equipped with cable guide frames and comply with regulatory requirements.Small safe operation distance: Circuit voltage (kV) of external power lines<~~~ Small safe operation distance (m) Setting requirements: A small safe distance should be maintained between the outer edge of the construction electric elevator and the edge of the external overhead power line.

Setting requirements: The foundation and foundation of the construction electric elevator should meet the requirements of the user manual. Before installing the construction electric elevator, the foundation should be inspected and accepted according to the requirements of the specifications. Only after passing the inspection can the installation be carried out.And prevent it from starting normally. There should be no device that allows users to cancel warning signals.The safety bulletin board for construction electric elevators should be hung at the protective shed of the electric elevator, with a size of meters by meters.Credit guarantee,For customers to use and operate the lifting platform for a long time, the editor briefly introduces how to maintain and repair the lifting platform: First of all, normal maintenance is mainly focused on prevention, especially if any damage or malfunction is detected and corrected or repaired in a timely manner. Careful inspection and maintenance at this time can save costs and avoid larger problems, resulting in costly repairs.Emergency manual valve: In case of power failure, it can cause the car to descend to the nearest floor position and open the doorLow level doors should be equipped with interlocking devices that can verify their closed and locked positions. The action of this interlocking device should be at the entrance of the cage. Simple use should not interfere with the operation of the interlocking device. The attached wall bracket should use matching standard products. When the wall bracket cannot meet the requirements of the construction site, it should be designed separately. The design of the wall bracket should meet the requirements of component stiffness,SwarthMiddleburg,SwarthJade Spring, strength, stability, etc., and the production should meet the design requirements.

Spiral electric lifting mechanism: With all the functions of a regular lifting platform, the main feature is that the equipment occupies a small foundation pit and has a large stroke. The equipment has a height of only -mm and a travel distance of up to m. It is particularly suitable for buildings with stages built on two or more floors due to space constraints.Latest quotationHorizontal lead screw mechanical electricityBefore installing the construction electric elevator, the foundation should be inspected and approved before installation.The list of materials for making landing doors is as follows: Table : List of materials for making landing doors. Landing doors should be installed at the entrance of each landing station, and the landing doors should function properly.Swarth,There is no need to set up a computer room above the shaft like an elevator,SwarthDa Venter, and the top floor height can be installed at least . meters.Principle of electric elevator rotary valve: When the electric elevator rises, the rotary valve will automatically open. To close the plug valve, it is necessary to first turn the handle to turn the plug to a degree position until it is closed, and then turn the transmission handwheel to lower the plug and achieve sealing.Use floor doors and cage door devices on construction sites where conditions permit.