For example, it has a great impact on the impeller of the equipment itself. So how to detect whether the equipment has cavitation during use?　　The high-pressure water flows to the space occupied by the original bubble at a very high speed, forming an impact force. The metal surface of the pump was fatigued and damaged by these impacts. Cavitation is caused by air bubble rupture and material stamping due to the difference in air temperature and pressureAz Zubayr ,　　 minimum gauge pressure at pump seat outlet MPa　　The of descending axial force can be used for slurry transportation in power plants, hydraulic and other professions; The mechanical seal is tight and reliable, and the leakage probability does not exceed drops /min, which is mostly used to transport flammable, explosive, toxic, strong corrosive and valuable liquids or materials with high temperature,　　In recent years,Az Zubayr Vertical heavy-duty slurry pump, the demand for submersible slurry pumps has increased greatly. In many fields,Az Zubayr WQ submersible sewage pump, submersible slurry pumps have replaced vertical slurry pumps. What are the differences between the two? Let&#;s yze.　　 repair and level the welding part of the submersible slurry pump with a file, clean the part to be bound with alcohol again and wipe it dry.　　The Tao part also consumes part of it.

　　 The rotor assembly is designed according to the actual situation, and the operation is more stable!　　 hydrogen sulfide gas content mg/l　　 selection of flow: single suction pump or double suction pump shall be selected according to the flow; single suction pump or multi suction pump shall be selected according to the lift.technical service,　　In fact, the impeller clearance of submersible slurry pump is not adjustable for all types of pump, but it is adjustable. During normal operation, the clearance needs to be adjusted regularly to keep the clearance within the range suitable for normal operation.　　Then it can enter into the volute pump housing. Then in the volute pump casing,Az Zubayr Submersible sewage pump, the medium slows down because the flow channel is also gradually expanding.　　Submersible slurry pump it fills the gap in the application of slurry pump. When the submergence is deep and there is no good mud outlet, that is, the traditional slurry pump cannot be installed and operated, and the submersible slurry pump can supplement this part of the blank work point.

　　 Then tighten the compression nut on the packing gland evenly to make the liquid leak out in drops, and pay attention to the temperature rise outside the packing chamber.Test conclusion,　　Promote the continuous expansion of the sales network group.　　This series of slurry pumps have wide range, good cavitation and high efficiency. Flow passage parts have good wear resistance. Belt drive can be used to adjust the speed through the main adjusting pulley to adjust the flow and head.　　In fact, the pumps I am going to talk about here have a wide range of uses. Pumps are required for both civil and military purposes, as well as for advanced technologies especially in the mining, chemical, metallurgical and other industrial sectors. It is a widely used general mechanical equipment. Most pumps are corroded or severely corrodedAz Zubayr ,　　 If there is no corresponding water leakage sensor, it is necessary to regularly maintain the submersible slurry pump and replace the seals.　　About %) and motor power p=i × U indicates that high power and current will increase.　　The seal cannot bear the water pressure at this depth. Once the water leaks, the motor will not work normally