the expansion coefficient is the same, and the connection with the water separator is not easy to leak. Scope of application: As the copper pipe is more expensive than the plastic pipe, the cost of the floor heating system is higher.Red copper inventory in key areas has risen continuously, but the total pressure is not big. From the current overall inventory situation of the main distribution centers Wu an, Jiangyin and Lecong, the inventory level remains relatively moderate and the pressure on the market is relatively small. In Wu an market, according to the data, as of May ,DelmasHollow aluminum pipe, the total inventory of medium and thick plates in Wu an was close to tons, increasing by tons on a weekly basis. In late April, it reached tons lower in the year, down tons from the high level after the Spring Festival, it should be said to maintain a relatively moderate level.Delmas,In addition, it is very strong, not easy to be corroded, and can adapt to various environments. It can be used normally at low and high temperatures, so copper pipes need to be selected many times in other places. The color change on the outer surface of the copper tube is difficult to control due to environmental factors. To prevent moisture absorption on the surface and core of the annealed brass tube a constant temperature and humidity packaging room can be built. Packaging in the packaging room can avoid the color change on the outer surface of the copper tube. However, it is not easy to control the situation that occurs in the processing process. The cost of ensuring constant temperature and humidity in the whole workshop is too high. The following measures are taken to control the process materials: In the season of high temperature and humidity, during the production and processing of copper tubes, the amount of oil coating on the surface of copper tubes can be increased to form an oil film on the surface of copper tubes, which can isolate water vapor and corrosive gases, and prevent the corrosion of the surface of copper tubes; The humidity in the air at night is high, and the outer surface of the copper pipe is prone to corrosion and discoloration at night. Closing the doors and windows of the workshop at night can make the situation worse; After the coil surface is cleaned in the rewinding process, the coating amount of passivation agent on the copper tube surface is increased. After blanking in the rewinding process, plastic bags shall be added to the whole support material to further reduce the contact between the copper pipe and the air and prevent the surface of the copper pipe.Save materials and total cost, stability and performance, and can save maintenance.Page,Let s elaborate on the advantages of copper pipe materials: copper pipe floor heating refers to a heating method that uses hot water as the thermal medium, circulates in the copper pipe heating pipe, heats the floor, and heats the floor through the ground in the form of radiation and convection heat transfer. I. The copper tube has fast heat dissipation effect and strong heat resistance. Even under the condition of high temperature water supply, the service life of the floor heating tube will not be affected. Two. Copper pipe is a metal pipe,o it is not easy to scratch. Therefore, it is not easy to leak. Three. High temperature resistance, high pressure resistance, relative to any ordinary plastic pipe. Copper tube floor is warm and resistant to high temperature and pressure. Four. Long service life. Five.Red copper bars in other regions basically follow the price trend of Tangshan, in which the bid of Jiangsu Steel Works tends to be higher, and most of the downstream prices are asked, and the overall market transaction is fair. The steel mills in Wu an are limited in receiving orders, and the market resources are tight. Most of the merchants are reluctant to sell. Shanxi billet market offers vary, and it is difficult to clinch a deal. The willingness of downstream customers to receive orders is weak, so they hold a cautious wait-and-see attitude. At prepresent, the steel market is in the & quot; golden third& quot; peak season. The market has a good expectation of the future market and a strong willingness to support prices. It is expected that the prices of Tangshan mainstream billets will be stronger next week.The composite method of three production methods of copper tube is also a high-tech production method for this method. It is a copper material containing impurities. Those copper materials, copper alloys and composite copper materials are put together by electrochemical reaction to produce a nanocrystalline copper material, and then the material is purified to produce copper tube materials.

In the middle and late ten days, although there were good news such as the rise of futures and the increase of production restriction policy in Wu an region, due to the high inventory level, traders had no desire to increase prices, most of them had shipped goods, and spot prices lacked motivation to rise. The market inventory rose significantly. At that time, it is often used in some ah heat exchangers to Kazakhstan oxygen equipment.Extrusion method: This production method is to cast copper ingots after smelting and the continuous rise of inventory led to the empty market mentality.Therefore, and extrude copper tubes by large extruder after secondary heating.AdministrationRed copper bars in other regions basically follow the price trend of Tangshan, in which the bid of Jiangsu Steel Works tends to be higher, and most of the downstream prices are asked,Delmas20CrNiMo alloy steel plate, and the overall market transaction is fair. The steel mills in Wu an are limited in receiving orders, and the market resources are tight. Most of the merchants are reluctant to sell. Shanxi billet market offers vary, and it is difficult to clinch a deal. The willingness of downstream customers to receive orders is weak,Delmas201 stainless steel plate, so they hold a cautious wait-and-see attitude. At prepresent, the steel market is in the & quot; golden third& quot; peak season. The market has a good expectation of the future market and a strong willingness to support prices. It is expected that the prices of Tangshan mainstream billets will be stronger next week.The copper bar market declined steadily this week, some steel mills in Jiangxi have resumed purchasing recently, but the purchasing volume is not large. The purchase price of pig iron in Yunnan steel plants was slightly increased to ensure the purchase volume due to the low purchase price of pig iron in the early stage. Recently, the steel market has been in shock and adjustment, and the merchants are unstable. Steel mills in Hebei, Tianjin and other regions have stopped producing pig iron for steelmaking. Now, it is mainly expected to make inquiries. However, due to the lower price of raw materials, the price of iron mills has been lowered.The blowpipe shall be perpendicular to the lead pipe during welding, and the flame shall be moved continuously to prevent local overheating and the flux from carbonizing before filler metal is added.

The conductive production of copper tube is the latest method for this method. It is the production of nanocrystalline copper materials with conductivity. Because this raw material is very special, it is a copper material produced by using nanotechnology, and copper ions can be separated by conductivity, so that copper tubes can be produced with the separated copper ions. This method is very complex, requires high technology and new equipment, so only advanced foreign countries can use this production method.Design brand,Disadvantages of copper pipe As far as copper pipe is concerned, high production cost and high price are its biggest disadvantages. Compared with other pipe fittings the cost of copper pipe is much higher, and the connection at the copper pipe interface requires high construction technology level.Re treat the water quality.After the pipe is cleaned, the welding flux and flux shall be immediately applied to the interface and the bayonet clearance. Sufficient flux shall be thinly coated on the mating surface and assembled immediately,Among the three production methods of copper tube, the oxidation method is the most. Because as long as the metal copper is oxidized by the anode and the copper ion of the anode is attached to the tube material, the copper tube can be produced. Thisthod is also the most common method to produce copper materials. It has not only been used for a long time, but also has a mature technology, which is to produce copper tubes through oxidation reaction. This production method is the main production method of copper tubes in China.Strong connection firmness of copper pipe: the connection between copper pipe and copper fittings is strong.In addition, it is not easy to be corroded and can adapt to various environments. It can be used normally at low and high temperatures, so copper pipes need to be selected for many times in other places.