The setting of the cable guide frame should comply with the user manual and regulatory requirements.Drivers of construction electric elevators should hold special construction operations and are not allowed to operate without a certificate.Mohong Mazar Castle,The shutdown device (emergency stop switch) should be non automatic reset type.Setting requirements: Before starting work every day and changing shifts, the driver of the construction electric elevator should inspect the construction electric elevator according to the requirements of the user manual and specifications, record the inspection results, and report any problems found to the user unit.Azor,Setting requirements: Drainage measures should be set up for the foundation of construction electric elevators to ensure smooth drainage.Setting requirements: The verticality deviation of the installation of the guide rail frame of the construction electric elevator should comply with the requirements of the user manual and specifications, as specified in the above table.Operating cost advantage and low failure rate: Due to the use of advanced hydraulic systems and good methods, the operating failure rate can be reduced to a low level.

When the horizontal distance between the edge of the cage and the edge of the landing or between the cage and the landing door is greater than mm and there is no effective protection from other structures, the side protection device for the landing entrance should be equipped.The device should be used within the valid calibration period and operate effectively and reliably. The anti fall safety device should have a valid inspection certificate (or inspection report), and the validity period should not exceed year. Anti fall safety devices have been manufactured for five yearsDuring normal operation, the horizontal distance between the closed cage door and the closed landing door should not exceed mm. Otherwise, measures should be taken to make it meet the requirements, or side protection devices at the entrance of the landing station that meet the requirements should be equipped. The distance between any opening between the side protection device and the hanging cage or landing door should not exceed mm.Quality Assurance,The net height of the landing door opening should not be less than m, and the difference between the net width and the outlet width of the cage door should not exceed mm. When the floor door is closed, except for the gap between the lower part of the door that should not exceed mm the size of any through-hole and opening related to the distance between any door and adjacent moving parts, should comply with the provisions of Table of 'Mechanical Safety - Safety Distance to Prevent Upper and Lower Limbs from Touching Dangerous Areas' GB-.Vertical lead screw electric lifting mechanism: Adopting a lead screw transmission method, and different steps can be formed within the travel range to meet the needs of meetings and performances; Pavilion, Terrace Tower, Pavilion; Ideal props.The list of materials for making landing doors is as follows: Table : List of materials for making landing doors. Landing doors should be installed at the entrance of each landing station, and the landing doors should function properly.

The scissor type electric elevator is a widely used high-altitude operation special equipment. Its scissor mechanical structure ensures high stability of the lifting platform, wide working platform,Mohong Mazar CastleSantander, and high bearing capacity, making the high-altitude operation range wider and suitable for multiple people to work simultaneously. It makes high-altitude operation more efficient and saferWork courses,Setting requirements: The wall bracket should use the manufacturer's matching standard products.The stopper bearing of the mechanism is kept intact.Speed limit wire rope switch. When the speed limit wire rope trips or breaks. Make the electric elevator unable to start.Mohong Mazar Castle,Setting requirements: The quality of the standard section should meet the requirements of the product manual. Before installing the construction electric elevator,Mohong Mazar CastleTeveso, all components should be inspected, and standard sections and other components with severe wear and deformation should be replaced.Secondly, the lifting platform is driven by electrical energy and lifted by the hydraulic system. During operation,Mohong Mazar CastleBrunswick, it is necessary to avoid irregular operations. To ensure the normal and orderly operation of the lifting platform and achieve the ideal unloading level, timely inspection of various functions is essential.Setting requirements: Each landing entrance should be equipped with a landing door, which should cover the opening with its full width, and should not open towards the lifting passage.