Pump,　　Transmission type: direct drive, parallel belt drive upper and lower belt drive, CV vertical belt drive,GorhaburDeep well pump, etc. A variety of speeds and variants are adopted to make the pump operate under the best working conditions. It has long service life and high operation efficiency, and can meet many kinds of harsh transportation conditions.　　 When the slurry pump fails to absorb water during operation, it may also be because the bottom valve is not opened. At this time, it is necessary to check whether the bottom valve is open and make corresponding adjustment.Zareu,　　In fact, when the submersible slurry pump is blocked during use, it will not only have a certain impact on the working efficiency of the equipment during operation, but also cause serious damage to the equipment itself, so it is also a reminder that we are using it too　　 Inspection before installation: Check the specification, size and quality of thick and thin accessories.　　 First, screw down the bolts on the side bearing pressure cap, and then remove the nuts used for the connection between the three parts: discharge section, stuffing box body and bearing body; Then screw off the round nut on the shaft, and successively install the bearing inner race, bearing gland and retaining sleeve

　　What is the solution to this situation?　　Although they are both pipeline pumps among centrifugal pumps, there are still many categories. Next, let&#;s talk about some models of pipeline pumps and their respective uses.　　The packing seal, auxiliary impeller seal and mechanical seal are mainly used. Among them, the packing seal needs small leakage and is not suitable for transporting toxic,GorhaburWQ submersible pump parameters, corrosive and precious liquids; The sealing of the auxiliary impeller relies on the reverse pressure of the two sealing impellers during rotation to prevent the leakage of the medium, and can also play a role inranking,　　 Another possibility is that the gas is sucked in when the pump is in use.　　Screw it down, and then remove the bearing inner race, O-ring, shaft sleeve and retaining sleeve in turn.　　 Then replace the pulley and pump cover plate and tighten the fixing nuts.

　　 A vent pipe is installed at the bottom of the pump, so that when the pump is buried underground water will be injected into the bottom of the slurry pump through the vent pipe, so that a sand water mixture will be formed at the bottom of the slurry pump,　　In order to make the equipment perform better when it is used,GorhaburZD slurry pump, but this also needs to be based on its working principle. It can not be adapted at will when it is optimized.　　 There are many reasons for motor overheating. It may be because the power supply voltage is too high, or there is a problem with the water pump or the motor itself.　　 Another possibility is that the gas is sucked in when the pump is in use.Gorhabur,　　 If there is no corresponding water leakage sensor, such mechanical faults will cause the stator winding of the pump to be burnt out.　　 selection of flow: single suction pump or double suction pump shall be selected according to the flow; single suction pump or multi suction pump shall be selected according to the lift.