It may also be because the pump&#;s liquid supply pipe is blocked by other substances during normal use.　　 The working properties of the two pumps are also different. Because the sewage pump is driven by a motor, it generally has good voltage impact resistance. The submersible pump is of the type of quick opening and quick closing, so it usually uses some small Flow and small pressure.Ofachem,　　Vertical height from water outlet center of pump base to flow destination (m)　　The water slurry pump is a widely used equipment. Many people are interested in the water diversion and exhaust method of the slurry pump equipment. Now let&#;s talk about the water diversion and exhaust method of the submersible slurry pump: the submersible slurry pump needs to pump out the water to form a vacuum, and then supply water,Tallaght,　　 Next, it is necessary to check the water seal. If the water seal is bakelite and the wear is not too serious, you can place abrasive cloth on the glass or dry wood, and then grind the water seal of Boshan submersible slurry pump flat or turn it over for use. However, if the thrust rubber water seal is used, and the operation is simpler. The equipment is directly submerged for operation, and the site is cleaner.　　Pump. In addition, the submersible slurry pump is mainly characterized by 'slurry', which is wear-resistant and particle passing.

　　Limited. According to relevant materials, the diameter of the impeller after cutting shall not be less than % of the diameter of the standard impeller, otherwise the of the pump will have a very adverse change. After the impeller of the slurry pump is cut, the flow area in the pump body increases, which makes the flow increase after the impeller is cut.　　 The pump without self circulation cooling device shall not be exposed to the water surface for a long time to prevent the electric pump from overheating and damage.　　 First of all, we need to choose equipment with formal certificates when making choices. We must avoid buying some obsolete or inferior products. And sometimes when the pump is in use,OfachemWQ submersible pump parameters,　　The seal cannot bear the water pressure at this depth. Once the water leaks, the motor will not work normally, resulting in damage to the submersible slurry pump. The biggest difference between the submersible slurry pump and the horizontal slurry pump and the vertical slurry pump is that the motor of the submersible slurry pump and the shaft connected to the pump are integrated and sealed Closed.　　There are differences.　　There is a difference between submersible slurry pump and sewage pump. Although the media conveyed by the two are not pure water and other media,OfachemVortex pump and pipeline pump, the difference between slag slurry and sewage is still large. Let&#;s take a look at the difference between the two.

　　The non service life of the equipment is not as long as possible. If it is not used for a long time, it will not only easily corrode the parts but also reduce the service life of the parts.Test results,　　After understanding the working principle of the submersible slurry pump, we will also know that those parts are prone to wear during normal use. In this way we can carry out targeted anti-corrosion and wear-resistant treatment on these parts during optimization, so as to improve the integrity of the equipment and　　 discharge requirements for water leakage of pump seat packing　　It will burn out. If there is a heating problem in use, you can refer to the following reasons.Ofachem,　　The submersible slurry pump is developed to adapt to the increasingly complex working conditions and facilitate the use of users. Its use mode is more flexible. The equipment has advanced structure wide flow passage, strong sewage discharge capacity, excellent material selection and strong corrosion resistance. Suitable for conveying liquids containing solid particles, such as sandstone, cinder and tailings. So what are the requirements for its work? Let&#;s understand briefly.　　 in addition, the noise method directly detects the noise of the equipment in the detection process, but such measurement will also be affected by the surrounding noise, so in fact, such measurement is not very accurate.　　We also need to limit the starting frequency and select appropriate thermal protection devices for use.