There is a difference between submersible slurry pump and sewage pump. Although the media conveyed by the two are not pure water and other media,FeruzabadBooster pipeline pump, model selection parameters: outlet diameter, flow, dust, motor power, impeller speed, pumping rate, maximum particle and weight.Feruzabad,　　Domestic stainless steel pipeline pump products have greatly improved their technical level through introduction, absorption, renovation, digestion and innovation. In particular, the supporting products of some major technical equipment have reached or approached the advanced level of similar products. With the continuous expansion of the market, stainless steel pipeline pump　　 When starting the slurry pump, the outlet gate valve shall be (closed or slightly opened by /. Before starting the slurry pump, expand the pump inlet valve and close the pump outlet valve. Then start the pump. After the pump is started, slowly start the pump outlet valve. The size and speed of opening the pump outlet valve should be based on the fact that the pump does not vibrate and the motorMoro,　　 determination of model: for water pump or pump with physical and chemical medium similar to water, it is necessary to go to the relevant product catalog or sample, and make correction according to the performance table or performance curve of the model to see whether the normal working point falls in the priority working area of the pump.　　What is the order.　　When the slurry pump is working, the pump needs to be placed on land, the suction pipe in water, and the pump needs to be started. Due to the structural limitations of the mud pump and submerged slurry pump the motor needs to be placed on the water surface during operation, the motor will fall into the water

　　In addition to the method, materials shall be selected comprehensively according to the nature of corrosive medium, anti cavitation theory, corrosion mechanism of water pump and stress characteristics. In order to prolong the service life, protection should be done well, which should be a comprehensive optimization design method.　　 water quality: fine sand; Zhongsha; River and river water　　 The gas inadvertently entered in the equipment is discharged and good sealing performance is ensured.original,　　 The secondary pump shaft seal of the two-stage series pump is (packing seal), and the startup of the series pump also follows the above method. Only after the first stage pump is started, the noise method directly detects the noise of the equipment in the detection process, but this measurement will also be affected by the surrounding noise, so in fact, this measurement is not very accurate.　　Second, the power used is not matched, so the motor temperature will be too high after long-term overload operation; In addition,FeruzabadScrew deep well pump, frequent startup during use will also lead to fever, so I

　　Generally speaking, the above two cases are the case that the slurry pump does not absorb water. The solutions are also introduced. I believe that people can deal with this problem in time. However, if the problem is serious, you must not adjust it at will. At this time, you should find a professionalLatest consultation,FeruzabadPipeline pump body,　　Second, the service life of the flow passage parts of the pump is relatively long, saving production costs.　　The ability of dirt passing through makes it safer to use.　　Many people do not know much about the packing and sealing of equipment because of the equipment of mass and energy. Next let&#;s learn about the packaging and sealing method of the equipment: packing sealing is very common in submersible slurry pumps. This method has good sealing performance, is easy to use, and effectively reduces the wear of the host and anti vibration kinetic energyFeruzabad,　　It will burn out. If there is a heating problem in use, you can refer to the following reasons.　　Basically, it must be noted that if the fault is caused by electricity you can find the reasons from the above items. However, people who do not know electricity should not repair it by themselves, so as to avoid people　　When using the sand pump, be sure to pay attention to the steering divergence between the motor and the pump. The sand pump has an arrow on the pump to mark the main steering. After the power supply is connected, run the pump without load. Check whether the motor operates normally. During operation, be careful not to exceed the bearing on the pump support to avoid