After each use of the equipment, high-pressure water should be used to wash the pump and pipes. The washing can be stopped until the water has no impurities.　　The direction of the differential pressure force is opposite,CharikalSingle stage slurry pump, which can offset part of the axial force and prolong the service life of the bearing.Charikal,　　 Long term dehydration operation of submersible sewage pump: since the submersible sewage pump uses water as cooling water, the motor may overheat and burn due to long-term dehydration.　　If there is a standby pump, it is better to use two pumps in turn. If the pump is stuck, the pump can only be repaired. A net can be added at the water inlet to prevent too many impurities from entering the pump. In this way,　　The operating environment is different: the key difference between the submersible slurry pump and the vertical slurry pump lies in diving. During the operation of the vertical slurry pump, some parts intrude into the pit and cannot completely invade the slurry; The submersible slurry pump can completely penetrate below the slurry level.　　What stands out is the sealing of the container. The seal is easy to install and maintain, stable and reliable, but the price is quite expensive.　　The equipment is integrated with the oil cooler, with compact layout. The water pump meets the modular and integrated design requirements of diesel engine parts. The joint surface with oil cooler adopts rubber sealing method, which has good sealing effect. Submersible slurry pump is a kind of solid-liquid mixing medium with the help of centrifugal force

　　Different installation requirements: the vertical slurry pump needs to be fixed, while the submersible slurry pump does not need to be fixed. It can directly invade into the liquid for operation.　　Will it be damaged by underground humus and hot water? This is the concern of friends who want to buy stainless steel deep well pumps.　　 There is also a vibration method to measure the vibration frequency of the pump, and the measurement is relatively simple. However,CharikalRubber lining submerged slurry pump, when using one method, the measurement results may have some errors. When using the submersible slurry pump, there are other vibration sources that will affect the measurement results, so it is actually the mainsuperior quality,　　The non service life of the equipment is not as long as possible. If it is not used for a long time, it will not only easily corrode the parts, but also reduce the service life of the parts.　　The utility and durability of the utility model, so the polymer composite materials are generally used in production.　　If the oil seal ring of the shaft is seriously worn replace it with a new one.

　　Moreover, because the length of the long shaft is generally fixed, it is often troublesome to install it. Therefore,CharikalQJ submersible pump, when it is used later the place where it operates will also be limited. If the equipment willWelcome calls ,　　 Move the sand pumping site frequently. When the pump pumps sand at a fixed position and drops to a certain height, lift the submersible slurry pump and move it to the adjacent position of the previous sand pumping place to continue pumping sand, so as to move the sand pumping place back and forth for sand pumping, so that the sand pumping area in this area forms a honeycomb,　　The water pump is not installed firmly or installed too high.　　The above introduction is about the cause ysis of the overload of the slurry pump. When we find these conditions when using the pump we can check whether these reasons are the above. This is also a reminder that we need to maintain the pump during normal use. latentCharikal,　　Avoid airborne sound transmission; Ensure the airtightness of machine room doors and windows. The water pump is equipped with a sound proof cover, the inlet and outlet of the sound proof cover are equipped with silencing equipment. A vibration isolation platform is installed at the bottom of the water pump for foundation vibration reduction to isolate the vibration generated during the operation of the water pump　　For example, ash and slag are removed from the power plant, slime and dense medium coal are transported in the coal preparation plant, and slurry is transported in coastal river mining operations. The weight concentration of the treated slurry is: mortar %, ore slurry %; It can be operated in series according to the needs of users.　　Superior, complete protection s, reasonable structure, convenient installation and high cost performance. In case of sudden power failure of the plant and emergency, the water pump will automatically start to supplement the pipe network pressure.