(III) dry type transformers of KVA and below can be installed on poles. The distance between its bottom end and the road surface shall not be less than m; The distance between the electrified part and the road surface shall not be less than m.If the oil immersed transformer is burned by the cover of the transformer, when the oil immersed transformer fails, use detection equipment to put out the fire immediately. In order not to expand the hazard, the fire brigade must be notified.TombaDuring the operation of the transformer, we have a certain understanding of the optical wavelength of oil immersed transformer. What kind of function does it have for transformer?Gandia the resistance value of the grounding wire shall be measured accurately every two years.In specific daily life,Wiring mode of dry-type transformer:When the manufacturer of the power transformer samples from the automobile oil tank, after opening the sealing cover, use the cleaned and dried rubber stopper to the oil. At the same time, clamp the branch pipe with your thumb, and loosen your thumb to make the oil enter the pipe,The whole process of hanging the core of dry-type transformer is more critical, and there are many situations that the hanging core of dry-type transformer must pay special attention to. Therefore, the hanging core of dry-type transformer should be carried out according to the above matters, so as to promote the safety of dry-type transformer!

Manufacturing process and steps of dry-type transformerAt that time, only a few companies in China could produce kV high-voltage transformers, and the market share of high-voltage transformers was basically monopolized by overseas leaders.If the oil immersed transformer is burned by the cover of the transformer, when the oil immersed transformer fails, open the lower side of the transformer and place an appropriate part. When the oil immersed transformer is on fire, use detection equipment to put out the fire immediately. In order not to expand the hazard, the fire brigade must be notified.Safety and health,Equipped with a temperature controller,TombaCommon models of power transformer, platinum thermistor (pt) is placed beside the embedded hole on the top of the low-voltage solenoid coil to test the winding resistance temperature rise of the transformer, stop the cooling centrifugal fan,TombaOil immersed transformer 2500kVA, set up common problem alarm, overtemperature alarm and overtemperature tripping effect, and provide reliable overvoltage protection machinery and equipment for the dry test transformer, so as to test the safety performance of the transformer operation.The scientific research of power transformer oil is generally carried out according to the way of sampling. What are the common sampling methods and processes?What about oil immersed transformer fire?

Dry type transformer manufacturerQuality inspection report,The method and whole process of taking oil sample of power transformer are as follows:Transformer inspection earThe noise of dry-type transformer belongs to low-frequency noise. In a small area, most of it is scattered according to the building structure. This kind of low-frequency noise is scattered to the household house according to the house building, and then causes gas vibration noise, which is then scattered to the ears of consumers. Although the amount of noise is not very large, the dispersion spacing and adverse effects are very large.TombaThe capacity and working voltage are different. The dry-type transformer is generally suitable for distribution equipment. The capacity is generally below kVA and the working voltage is below KV,TombaOil immersed experimental transformer, which also ensures the rated voltage of kV; Oil immersed transformers are generally suitable for distribution equipment.A specific part of dry-type transformer is the hanging core of dry-type transformer. The hanging core of dry-type transformer is a vital component. How to carry out the hanging core?When the manufacturer of the power transformer samples from the automobile oil tank, after opening the sealing cover, use the cleaned and dried rubber stopper to the oil. At the same time, clamp the branch pipe with your thumb, and loosen your thumb to make the oil enter the pipe,