which is an individual mechanism that is integrated with a safety clamp; The entrance and exit of the passenger compartment should be equipped with safety doors. Public places

Speed limiter. To prevent the driving speed from exceeding the normal speed. A speedometer should be installed (not required for floors below or including the second floor), family dormitories,KoninDongzhou, andThe scissor type electric elevator is a widely used high-altitude operation special equipment. Its scissor mechanical structure ensures high stability of the lifting platform, wide working platform, and high bearing capacity, making the high-altitude operation range wider and suitable for multiple people to work simultaneously. It makes high-altitude operation more efficient and saferKonin,Lower limit switch: In normal working state, before the suspension cage touches the buffer, the lower limit switch first acts.Drivers of construction electric elevators should hold special construction operations and are not allowed to operate without a certificate.Kayseri ,Installation verticality deviation guide rail frame erection height, the verticality deviation of the guide rail frame should not exceed (/) h.The safety bulletin board for construction electric elevators should be hung at the protective shed of the electric elevator,KoninAvignon, with a size of meters by meters.The setting of the cable guide frame should comply with the user manual and regulatory requirements.

The net height of the landing door opening should not be less than m, and the difference between the net width and the outlet width of the cage door should not exceed mm. When the floor door is closed, except for the gap between the lower part of the door that should not exceed mm,KoninMesa, the size of any through-hole and opening related to the distance between any door and adjacent moving parts, as well as the gap around the door or between parts, should comply with the provisions of Table of 'Mechanical Safety - Safety Distance to Prevent Upper and Lower Limbs from Touching Dangerous Areas' GB-.Items and other miscellaneous items.During the use period, the user unit should organize professional technical personnel to inspect the construction electric elevator monthly according to the standard requirements, and record the inspection results.Where is good,The use of a lifting platform as a tool for storing performance blankets, soft scenery, etc. In some theaters, there is a soft scenery storage lifting platform located at an appropriate location on the stage for the storage of blankets, soft scenery, etc.Once again, weekly inspections should be conducted to check whether the connecting screws at various parts of the lifting platform are tightened, whether the sealing rings are damaged or ineffective, whether there is a lack of hydraulic oil, and whether the oil cylinder is leaking. It is necessary to clean the lifting frame, wiring, and oil cylinder once a week to avoid dust and debris affecting normal operation.Tank oil temperature protection: When the oil temperature in the tank exceeds the standard setting value, the oil temperature protection device sends a signal to suspend the use of the elevator. The elevator can only be started when the oil temperature drops

The spacing between wall brackets and the height of guide rails above the high attachment point should comply with the requirements of the user manual.OK or not?,Setting requirements: For construction electric elevators with foundations installed on roof slabs floors, or other lower suspended structures,Setting requirements: The anti loosening and anti loosening parts between the connecting parts should comply with the provisions of the user manual and should not be replaced by other objects. For connecting bolts with pre tightening requirements, a torque wrench or special tool should be used to accurately tighten the bolts to the specified torque value according to the specified tightening sequence. When installing standard section connecting bolts, it is advisable to place the screw at the bottom and the nut at the top.Implementing multiple shifts of homework should fill in and submit records according to regulations.The spacing between wall brackets and the height of guide rails above the high attachment point should comply with the requirements of the user manual.