flow and liquid delivery. The flow range of the delivered liquid is - L / s, the pressure range is .- MPa, and the diesel engine speed range is - rpm. Features: water pump, high automation and performance　　Strong strength and other advantages. It is widely used as a sealing device for various pumps. Place a water seal ring at the bottom of the packing box, and then place the filler.Nasiriya,　　 The valve shall be used to regulate the flow and head, and overload operation is not allowed.　　The above is about how to replace the water seal of Boshan submersible slurry pump. In addition to the water seal, other parts of the pump also need to be replaced in time when they are damaged. Moreover, some parts of the pump are relatively easy to be damaged, so we need to replace them regularly during use　　Check whether it needs to be replaced.Briceni, it belongs to a portable workstation, which can be brought wherever it is needed, because it does not need too many auxiliary facilities.　　In order to make the equipment perform better when it is used, but this also needs to be based on its working principle. It can not be adapted at will when it is optimized.　　 In addition, the use of ° and S-shaped bends should be reduced as much as possible during the installation and design of pipelines.

　　 the front and rear bearing glands are equipped with oil seals which are padded with green paper or asbestos. There is a gap of .- mm between the rear gland and the bearing.　　The microcomputer controller of the water pump control cabinet displays E: cause: the parameter of the microcomputer controller is edited incorrectly.　　 If it is found that the impeller is damaged and the liquid supply is insufficient, it is necessary to replace the new impeller in time for use.Market trend,NasiriyaBooster pipeline pump,　　 The fan speed of the water pump is too low, and the air pressure and air volume are relatively small, so the heat cannot be dissipated.　　The use of water pumps is related to all aspects of our life. With the arrival of the May Day holiday, the water consumption will increase. Therefore, it is necessary for us to choose a suitable water pump.　　 If the head of the submersible slurry pump is too low or the head is higher than the practical condition, the flow will be large and the current will rise. At this time, and the measurement is relatively simple. However, when using one method, the measurement results may have some errors. When using the submersible slurry pump there are other vibration sources that will affect the measurement results, so it is actually the mainLatest quotation,　　 Dust and oil stains on the motor reduce the heat dissipation capacity of the equipment and cause the equipment temperature to rise.　　 during operation, the deep well pump shall rotate smoothly without vibration and abnormal sound. Observe whether there is obvious fluctuation in the motor running current and line voltage before and after startup. The change of water level in the well shall be observed frequently. The motor must not be exposed to the water surface or sink into the sludge to avoid affecting the power supply　　The non service life of the equipment is not as long as possible. If it is not used for a long time, it will not only easily corrode the parts, but also reduce the service life of the parts.Nasiriya,NasiriyaSubmersible slurry pump,　　The Tao part also consumes part of it.　　Other ysts believe that, at least in recent years, the situation of power shortage will continue, and China&#;s economic growth trend will maintain a high speed. Therefore,NasiriyaLong shaft submerged slurry pump, the contradiction between power supply and demand is still prominent in recent years which is undoubtedly an opportunity for it and the generator industry. In water pumps and generators, especially　　To repair the equipment. Submersible slurry pump is a machine used to transport liquid. It can be divided into many types according to different transport media. Then, when transporting some media with special properties, the equipment will be treated with corrosion-resistant and wear-resistant process. Only in this way can the equipment be improved