Rotate in the rolling direction until the friction between the impeller and the front guard plate stops, then use the adjusting bolt to move the rotor backward record the forward and backward movement gap, the front guard plate and the rear guard plate is flat, stop, and tighten the two dust discs and fasten them on the shaft. adjustment　　 Cutting blades can be selected to cut some large block solid substances into pieces during use, so that blockage can be avoided during reuse.Tricara,　　The structural characteristics are described respectively.　　 one method is to use ultrasonic method to detect whether the equipment has cavitation. This method is often convenient for re detection. Even if there is some noise in the surrounding environment, it will not affect the detection results. Therefore, many pumps tend to have better measurement results when in use.Lonceston,　　 It is also possible that the fan blades of the pump are few and the air volume is insufficient, resulting in poor heat dissipation effect.　　The equipment is integrated with the oil cooler,TricaraDeep well pump, with compact layout. The water pump meets the modular and integrated design requirements of diesel engine parts. The joint surface with oil cooler adopts rubber sealing method, which has good sealing effect. Submersible slurry pump is a kind of solid-liquid mixing medium with the help of centrifugal force　　The slurry pump should be larger. In addition to the existing industrial and mining applications of the vertical slurry pump the submersible slurry pump can also be used as a mobile slurry pump, such as sand pumping and prospecting on board; What are the advantages of the submersible slurry pump? The advantage of the submersible slurry pump is that it is convenient and flexible,TricaraSelf priming slurry pump wholesale, the biggest advantage is that it is flexible, convenient and easy to apply to various working conditions. The most important technical point of submersible slurry pump is the tightness between its motor and pump body Stability and reliability of seals.　　 For protection during operation, a temperature sensor is generally installed on the stator to detect the temperature of the stator. In case of dry operation due to lack of medium, the wear of the stator and rotor will be very large, and the temperature will increase with friction,TricaraRubber lining submerged slurry pump, further increasing the wear. therefore　　Do a good job of fixing to avoid the motor falling into the water and directly scrapping.Information recommendation,　　 A vent pipe is installed at the bottom of the pump, so that when the pump is buried underground water will be injected into the bottom of the slurry pump through the vent pipe, so that a sand water mixture will be formed at the bottom of the slurry pump, so that the slurry pump can be started normally. The advantage of this approach is that even if　　Water flow into the bearing damages the bearing.　　Second, the service life of the flow passage parts of the pump is relatively long, saving production costs.

　　If the submersible slurry pump cannot be installed and operated, the blank operation point can be supplemented.assets, the correct application is very important. Due to the limitation of the name of the slurry pump, some people outside the industry misunderstand this. In fact, the impurity pump, dredging pump, desilting pump, etc. are all in the application scope of the slurry pump　　 Various matching forms of long shaft deep well pump　　 Then reinstall the equipment on the engine and install the rubber hose.Tricara,　　It is an auxiliary means for some on-site monitoring.　　It needs to be replaced in case of damage, swelling and deformation, insufficient spring pressure, breakage, etc.　　 Selection of pipeline diameter: the selection of pipeline shall consider the one-time purchase cost, long-term operation cost and operation reliability.