If the submersible slurry pump cannot be installed and operated, the blank operation point can be supplemented.　　It is occasionally found that there is insufficient liquid supply when using, so what are the reasons for this situation and how to deal with it.Tokyo Ze,　　For the pipeline pump in the workshop, it is necessary to consider whether the pipeline pump is worn to a certain extent due to inadequate maintenance, but the performance of the pipeline pump is degraded. In case of abnormal water absorption during installation, check the motor during installation, and check the motor wiring and speed,　　After that, before starting again, check whether the impeller rolling is normal and whether the bearing assembly compression bolts are tightened, and then start the pump.Lakhdaria,　　We also need to limit the starting frequency and select appropriate thermal protection devices for use.　　Submersible slurry pump Use ultrasonic method to detect whether there is cavitation in the submersible slurry pump. This method is often convenient for re detection. Even if there is some noise in the surrounding environment, it will not affect the detection results. Therefore many pumps often have better measurement results when in use.　　The fruit is also bad; When the axial flow pump is used, its water output is relatively large, but the head is not too high, so the effect of using the submersible slurry pump in many plain areas is also relatively good; The water output and head of the mixed flow pump are actually derived from one

　　 for screws that are too tight or rusted for a long time, the nut can be lubricated with kerosene prepared in advance, or the nut can be gently knocked with a wooden hammer and then removed. This method can also be used in slurry pumps and other places.　　The microcomputer controller displays E: cause: the pressure gauge is disconnected (f= or the input signal is

　　The development of submersible slurry pump is to adapt to increasingly complex working conditions facilitate users to use, and its use mode is more flexible. And it fills a part of the gap in the application of slurry pump. When the submergence depth is deep and there is no better slurry outlet that is, in the traditional slurry pumpThe cheapest,　　In addition to the method, materials shall be selected comprehensively according to the nature of corrosive medium, anti cavitation theory, corrosion mechanism of water pump and stress characteristics. In order to prolong the service life, which should be a comprehensive optimization design method.　　During the long-term overload operation of submersible sewage pumps, there are many cases of sudden abnormal failures of submersible pumps. Among them, there are some common obstacles, such as the submersible pump cannot be started after it is powered on, or the motor speed cannot be started after the submersible pump is started. A very small wait　　 First of all, let&#;s understand the causes of insufficient liquid supply: If the liquid level stored in the circulating liquid storage tank is lower than %, then insufficient liquid supply will occur when it is in use. Or the pump adds too much lubricating oil,Tokyo ZeQJ submersible pump,Tokyo ZeHH slurry pump,　　How to disassemble the submersible slurry pump and how to assemble it after disassembly. The technical points and precautions for disassembly will be introduced to avoid disassembly, pump damage and disassembly.　　Only in this way can its service life be extended to a large extent.　　Rotate in the rolling direction until the friction between the impeller and the front guard plate stops, then use the adjusting bolt to move the rotor backward, record the forward and backward movement gap,Tokyo ZeAh slurry pump, evenly distribute it between the front and rear guard plates of the impeller until the gap between the impeller, the front guard plate and the rear guard plate is flat, stop, and tighten the two dust discs and fasten them on the shaft. adjustment