The verticality of the guide rail frame should meet the requirements of the specifications.Low power consumption: When the hydraulic guide rail lifting platform descends, it is driven by the pressure generated by its own weight, greatly saving energy and reducing consumption.Indianapolis,Before each shift of work, the safety devices of the construction electric elevator should be inspected to ensure sensitivity and reliability.Safety grounding device. In order to protect against electrical equipment. The metal casing of electrical equipment and the metal structure of electric elevators should be equipped with a safety grounding device. The grounding wire should operate multiple wires and the neutral wire should not be arbitrarily held as a safety grounding wire. Its grounding resistance should not exceed ohms; The power supply of the electric elevator can be cut off.Ujida,When the horizontal distance between the edge of the cage and the edge of the landing or between the cage and the landing door is greater than mm and there is no effective protection from other structures, the side protection device for the landing entrance should be equipped.Setting requirements: The spacing of wall brackets along the vertical direction should comply with the provisions of the user manual.When the landing door is closed, the full width of the lifting passage opening should be covered.

Work is essential, and the main protective accessories include safety belts, guardrails, protective covers, platforms and stairs, etc.Precautions during operation: Mechanical operations should be gentle and smooth, and mechanical operations should be avoided, otherwise impact loads will inevitably occur, causing frequent mechanical failures and greatly shortening the service life. Generated during homeworkThe setting of the cable guide frame should comply with the user manual and regulatory requirements.Product survey,IndianapolisZamohik,During loading and unloading, the horizontal distance between the edge of the cage door and the edge of the landing station should not exceed mm.The scaffolding of the parking platform should be laid tightly and firmly.Operating cost advantage and low failure rate: Due to the use of advanced hydraulic systems and good methods,The bearing capacity of the building structure at the attachment point of the wall bracket should meet the requirements specified in the user manual for construction electric elevators.The water cooling of hydraulic stations is generally tubular water cooling. The selection is based on the heat load to calculate the heat exchange area, while the air-cooled electric elevator uses an air cooler to calculate the heat exchange capacity based on the heat load. Then, the selection calculation is carried out under the condition of satisfying the flow rate. So, these two types of cooling are different and have significant differences.Stage equipment safety door. To prevent personnel from extending their heads,IndianapolisDa Kelesh,IndianapolisProv, hands, and feet out of the shaft and objects from falling into the vertical shaft. Its vertical position should be closed, its cabin should be full of doors, and the height of the hoistway (hall door) should not be less than meters; The electric door opening and closing switches should be removed from the vertical and passenger compartment doors. In order to prevent accidents caused by vertical, passenger car doors, and car roof doors not being closed.; Door interlocks should be installed on both the vertical and passenger compartment doors.Indianapolis, strength testing report.It is understood that the scissor type lifting platform is a widely used specialized equipment for high-altitude operations. Its shear fork mechanical structure provides high stability for the lifting platform, wide working platform, and high load-bearing capacity making the range of high-altitude operations larger and suitable for multiple people working simultaneously. The lifting power is divided into V, V or V power supplies, diesel engines, using Italian and domestic hydraulic pump stations, and the table top is equipped with anti slip insulation buckle plates, which have anti slip, and safety features. Please rest assured to use.The quality of the standard section should comply with the product manual and specification requirements.