Rotate in the rolling direction until the friction between the impeller and the front guard plate stops then use the adjusting bolt to move the rotor backward, record the forward and backward movement gap,HoramabadPipeline pump, evenly distribute it between the front and rear guard plates of the impeller until the gap between the impeller, the front guard plate and the rear guard plate is flat, stop, and tighten the two dust discs and fasten them on the shaft. adjustment　　 The working properties of the two pumps are also different. Because the sewage pump is driven by a motor, it generally has good voltage impact resistance. The submersible pump is of the type of quick opening and quick closing, so it usually uses some small Flow and small pressure.Horamabad,　　Pumps, self-priming pumps, sewage pumps, chemical pumps and other pumps can also be called pipeline booster pumps.　　 Moreover, the processes of these two pumps are also different and the sewage pump can generally be adjusted. Submersible pumps are generally used in some special or other places.Delta,　　When the water pump is driven by electricity or diesel engine its impeller (like an electric fan) rotates wildly, thus forming a vacuum in the impeller. In this way, the atmospheric pressure will move the water pressure to pump water. In fact, from a al point of view, it is to convert electrical or chemical energy into gravity　　Start the priming pump. Moreover, due to the structural limitations of the submersible slurry pump, the motor needs to be placed on the water surface for use during operation, and then the pump needs to be placed in the water for use. Therefore, the submersible slurry pump must be　　Yes, summer is the peak sales season. In addition to agricultural applications,　　The high-pressure water flows to the space occupied by the original bubble at a very high speed, forming an impact force. The metal surface of the pump was fatigued and damaged by these impacts. Cavitation is caused by air bubble rupture and material stamping due to the difference in air temperature and pressure　　 there is also a simple method to measure the vibration frequency of the pump by vibration method. However, when using one method, there may be some errors in the measurement results. When many equipment are used, there are other vibration sources that will affect the measurement results. Therefore, in fact,HoramabadVortex pump and pipeline pump, it belongs to a portable workstation, which can be brought wherever it is needed, because it does not need too many auxiliary facilities.

　　 To ensure the efficient operation of the submerged slurry pump, the clearance between the impeller and the front guard plate must be adjusted regularly to keep it between (.-mm). In addition to monitoring the flow and pressure during the operation of the pump, the motor shall not exceed the rated current of the motor. Monitor oil seal and bearing at any timeEconomic management,　　Extend service life. In fact, the submersible slurry pump is widely used in many lives, and there is a very important component water seal in the pump, so it mainly plays a role in use　　 the float switch can automatically control the start and stop of the pump according to the required liquid level change, without the need for special personnel, which is very convenient to use.　　Flexibility. The equipment has advanced structure, wide flow passage, strong sewage discharge capacity, excellent material selection and strong corrosion resistance. It is suitable for conveying liquids containing solid particles,HoramabadFire deep well pump, such as sandstone, cinder and tailings. So what are the requirements for its work? Let&#;s understand briefly.Horamabad,　　 in addition, the noise method directly detects the noise of the equipment in the detection process, but such measurement will also be affected by the surrounding noise, so in fact, such measurement is not very accurate.　　 selection of flow: single suction pump or double suction pump shall be selected according to the flow; single suction pump or multi suction pump shall be selected according to the lift.　　At the same time, the supporting pipelines in the pump room shall be provided with vibration isolation elasticity.