Setting requirements: The foundation and foundation of the construction electric elevator should meet the requirements of the user manual. Before installing the construction electric elevator, the foundation should be inspected and accepted according to the requirements of the specifications. Only after passing the inspection can the installation be carried out.The foundation base or embedded parts should be fully embedded in the concrete foundation plate.Swarth,Correct use can also greatly improve work efficiency. So how should it be used?Installation and dismantling personnel and drivers should hold certificates to work.Bugojno,The function of the lifting platform in a theater is roughly as follows: the main lifting platform arranged in the main performance area of the stage is mainly used to quickly change the scenery. Typically, with&quo; Product; In the music and dance theater stage arranged in a zigzag pattern, the lifting platform, side car platform, and rear car turntable perform a rapid transformation of the entire or partial scene. This arrangement allows for rapid switching of three full sets.Use floor doors and cage door devices on construction sites where conditions permit.When the wall bracket adopts non matching standard products design calculations should be carried out.

The angle between the wall bracket and the horizontal plane should comply with the requirements of the user manual.High altitude operations and maintenance in areas such as repair, logistics, electricity, transportation, petroleum,SwarthMobile, chemical,SwarthElectric pillar elevator, hotel, sports center, mining, also known as hydraulic liftingConstruction electric elevators should be equipped with cable guide frames and comply with regulatory requirements.Analysis project,When the horizontal distance between the edge of the cage and the edge of the landing or between the cage and the landing door is greater than mm and there is no effective protection from other structures, the side protection device for the landing entrance should be equipped.Monthly maintenance and inspection of hydraulic lifting platform rollers, intermediate shafts and bearings, oil cylinder pin shafts and bearings, and at this position, the hydraulic ground should be - millimeters higher than the bottom of the box. If the hydraulic oil becomes dark, sticky, or has foreign objects such as gravel, it should be replaced in a timely manner ( # hydraulic oil). Annual maintenance and inspection of all hydraulic pipelines and joints of the lifting platform. The pipeline must not be damaged,SwarthElectric elevator, and the joints must not be loose. All joints must be tightened. Remove and disassemble the lowering valve of the lifting platform, blow out the plunger with compressed air, then install it and reinstall it. Drain and discard the hydraulic oil, tighten the joint, remove the oil filter, clean it with compressed air, and then return it to the oil tank and connect the pipeline.When the horizontal distance between the edge of the cage and the edge of the landing or between the cage and the landing door is greater than mm and there is no effective protection from other structures, the side protection device for the landing entrance should be equipped.

The bearing capacity of the building structure at the attachment point of the wall bracket should meet the requirements specified in the user manual for construction electric elevators.Let's see,When the horizontal distance between the edge of the cage and the edge of the landing or between the cage and the landing door is greater than mm and there is no effective protection from other structures the side protection device for the landing entrance should be equipped.Stop.The verticality of the guide rail frame should meet the requirements of the specifications.Swarth,Drainage measures need to be considered around the foundation. (Drain the accumulated water on the foundation).Installation verticality deviation guide rail frame erection height, h/mH≤ H& gt; verticality deviation/mm≤ (/h≤ ≤ ≤ ≤ pairs of steel wire rope construction electric elevators, the verticality deviation of the guide rail frame should not exceed (/) h.During loading and unloading