Acceptance: Concrete strength grade C, strength testing report.Drainage measures need to be considered around the foundation. (Drain the accumulated water on the foundation).Lamar,Construction electric elevators should be equipped with emergency stop switches and comply with regulatory requirements.The end height of the guide rail frame above the high attachment point should comply with the provisions of the user manual.Cerkezkoy,Once again, weekly inspections should be conducted to check whether the connecting screws at various parts of the lifting platform are tightened, whether the sealing rings are damaged or ineffective, whether there is a lack of hydraulic oil and whether the oil cylinder is leaking. It is necessary to clean the lifting frame, scissors, wiring and oil cylinder once a week to avoid dust and debris affecting normal operation.Human improper operation is the main factor causing malfunctions in scissor type electric elevators. When stacking goods, electric elevators should stack the goods neatly, during the operation of the electric elevator,LamarMesa, it may cause the electric elevator to lose balance. After the goods are stacked completely, ropes should be used to lock the goods,Lamarpeas, so that they are not afraid of the goods during the lifting process; Careless; Scattered downThe use of standard section connecting bolts should comply with the user manual and specification requirements.

Setting requirements: Drainage measures should be set up for the foundation of construction electric elevators to ensure smooth drainage.Degrees, m/s.Setting requirements: The guide rail should be rigid and flexible components such as wire ropes or chains should not be used.Safety and health,Protective measures should comply with regulatory requirements.Installation and dismantling personnel and drivers should hold certificates to work.The bearing capacity of the building structure at the attachment point of the wall bracket should meet the requirements specified in the user manual for construction electric elevators.

Double layer steel mesh: The diameter of the steel bars is mm,When the horizontal distance between the edge of the cage and the edge of the landing or between the cage and the landing door is greater than mm and there is no effective protection from other structures, the side protection device for the landing entrance should be equipped.The usual operation of landing and docking. The installation position of the upper limit switch should comply with the following: when the lifting speed is less than .m/s,LamarDelft, the upper safety distance L left after the upper limit switch is triggered by the hanging cage should not be less thanThe verticality of the guide rail frame should meet the requirements of the specifications.Lamar,Installation and dismantling personnel and drivers should hold certificates to work.The safety distance between the outer edge of the upper part of the landing door and the moving parts of the electric elevator during normal operation should not be less than .m; If the rated speed is not greater than .m/s, the safety distance can be .m.The bearing capacity of the ground under the concrete foundation plate should be greater than .Mpa.