Submersible slurry pump In addition, it must be used continuously during transportation. If there is an interval in the middle, it must be avoided that the interval is relatively long, so as to avoid the solidification of slurry in the pump when the operation is stopped.　　Some corrosive pastes containing crystals can also be transported. In the application range of slurry pump, the service life of slurry pump in this section is generally low. Of course,KotaPipeline pump body, different minerals, abrasionKota,　　The microcomputer controller displays E: cause: the pressure gauge is disconnected (f= or the input signal is

　　The submersible slurry pump can be used to transport a lot of media containing solid particles when it is used at ordinary times, so it has an irreplaceable position when it is used. What is its own structure when it is used.　　 check the cable and replace it if it is broken or broken to avoid leakage.　　 Pipeline layout: Firmly support the water pipe and drain pipe to prevent the force of the pipe from acting on the submersible slurry pump.Potential development,　　Through the introduction, we learned that the submersible slurry pump can be used to transport slurry when it is used at ordinary times. The relationship between its special structure is very close, but in fact,KotaLong shaft submerged slurry pump, it also needs to be used in a correct way when it is used at ordinary times. Only in this way can　　 A trash trap can be added at the position of the water inlet pipe and used at an angle of degrees, and then a filter screen is installed in the trap to filter impurities for the second time, so as to avoid the blockage of the submersible slurry pump during use.　　It is an auxiliary means of on-site monitoring. During the operation of the submersible slurry pump,KotaQuotation slurry pump, the condition of its overflow parts is very important to the overall operation. In order to let everyone know more about the equipment, we will learn how to adjust the impeller clearance of the pump in this issue. I hope it will help you.

　　It, generator and market formed at the beginning of construction have gradually formed a certain scale after more than ten years of rapid development. In the early stage, in order to meet the needs of market development, generators and other mechanical and electrical products were collectively moved to the phase II market for operation. With a good business environment, water pumps and generatorsproject,　　 Then tighten the compression nut on the packing gland evenly to make the liquid leak out in drops, and pay attention to the temperature rise outside the packing chamber.　　 Shaft seal part auxiliary impeller shaft seal: through the impeller action of a reverse centrifugal force, prevent the slurry from leaking out. When the positive pressure at the inlet of the pump is not greater than % of the pressure at the outlet of the pump, the single-stage pump or the first stage pump in series can adopt the auxiliary impeller shaft seal, and the auxiliary blade shaft seal is not required　　 The fixing method of the impeller is changed from screw thread to key clamp to prevent the impeller from falling off and causing damage!Kota　　We also need to limit the starting frequency and select appropriate thermal protection devices for use.　　Troubleshooting: first increase the water pressure, then inject water into the pump body, and then start the pump. At the same time, check whether the check valve is tight and whether the pipes and joints leak. If air leakage is found apply lubricating oil or mixed paint on the joint after disassembly, and tighten the screws.　　 confirm whether the pressure capacity of the pipeline meets the requirements, and conduct hydrostatic test if necessary.