In fact, the impeller clearance of submersible slurry pump is not adjustable for all types of pump, the clearance needs to be adjusted regularly to keep the clearance within the range suitable for normal operation.　　 Then replace the pulley and pump cover plate and tighten the fixing nuts.Islam QAL ` ah,　　 If the deep well pump is not used continuously after running in the well, it should be started up once a week and run for - minutes to prevent the electric pump from being started due to corrosion.　　 If the hot water within ℃ is recommended, the hot water pump must be used, otherwise the motor will not be burned due to too high medium temperature.Santander de Quilichao　　 Before starting the submersible slurry pump, the rotor of the rotating pump shall be smooth and even, the outlet sluice valve shall be closed, and water shall be injected into the pump to ensure that the pump is full of water without air.　　Limited. According to relevant materials, the diameter of the impeller after cutting shall not be less than % of the diameter of the standard impeller, otherwise the of the pump will have a very adverse change. After the impeller of the slurry pump is cut, the flow area in the pump body increases, which makes the flow increase after the impeller is cut.　　It can also be used for cooling and lubrication. Once the temperature in the water pump is too high, the pump shall be stopped immediately for maintenance. Otherwise,Islam QAL ` ahHorizontal slurry pump, the excessive temperature will not only affect the wear of small parts inside the equipment but also seriously affect the working efficiency of the equipment. So what is the reason for the high temperature of the equipment

　　Circumference. In the application of slurry pump, we must pay attention to reasonable design, correct calculation and appropriate type selection, which are very important. In addition to the main wheel, a set of stirring impeller is added at the bottom of the product, which can spray the precipitated slag into a mixture of water and solid particles　　 Types of motors for deep well pumps　　There is no need to equip auxiliary mixing or spraying equipment, and the operation is simpler. The equipment is directly submerged for operation, without noise and vibration, and the site is cleaner.Quality improvement,　　The fruit is also bad; When the axial flow pump is used its water output is relatively large, but the head is not too high, so the effect of using the submersible slurry pump in many plain areas is also relatively good; The water output and head of the mixed flow pump are actually derived from one　　Moreover, the leaked flammable, explosion and poisoning, and the consequences will be unimaginable.　　Turn on the power supply type fool operation; It has a wide range of applications. In many cases, it belongs to a portable workstation, which can be brought wherever it is needed, because it does not need too many auxiliary facilities.

　　After the submersible slurry pump leaves the factory, there is generally only outgoing cable, and the user needs to connect it separately during installation. If the connection is wrong, it will seriously affect the normal operation of the pump, so we should follow the correct steps to connect.Application process,　　 Protective packing of shaft seal the shaft seal pump shall regularly check the sealing water pressure and water volume, keep a small amount of cleaning water flowing along the shaft,Islam QAL ` ahSewage pump diving, regularly adjust the packing gland, check the packing and regularly replace the packing. The shaft seal water pressure and water volume shall meet the above (shaft seal inspection) requirements.　　Microcomputer controller LW light: cause: the light is on and the machine stops, the water level is low, the water level returns to normal, and the machine starts automatically.　　We also need to limit the starting frequency and select appropriate thermal protection devices for use.Islam QAL ` ah,　　Promote the continuous expansion of the sales network group.　　There will be no insufficient liquid supply or other problems.　　Stability and reliability of seals between pump bodies.