Impeller protection in order to ensure the operation of the submersible slurry pump,ZardabuSingle stage slurry pump, it is necessary to timely adjust the clearance between the impeller and the front guard plate. When adjusting the impeller clearance, first stop the pump, loosen the bolts pressing the bearing box, loosen the adjusting nuts, make the bearing components move forward, and roll the shaft by hand to press the　　If the submersible slurry pump cannot be installed and operated, the blank operation point can be supplemented.Zardabu,　　Try to select the pump with appropriate lift.　　The water slurry pump is a widely used equipment. Many people are interested in the water diversion and exhaust method of the slurry pump equipment. Now let&#;s talk about the water diversion and exhaust method of the submersible slurry pump: the submersible slurry pump needs to pump out the water to form a vacuum,ZardabuVertical slurry pump, and then supply water,Valparaiso,　　It is located in the middle, so it seems that many regions have good effects when using it.　　Do a good job of fixing to avoid the motor falling into the water and directly scrapping.　　If there are sundries blocked, the pump will not be filled with water. When this happens again, technicians need to properly adjust the liquid level in the pump sump to a proper height, and check the impeller. In case of damage or aging, it needs to be replaced in time,ZardabuSubmersible pump can pump sewage,

　　Whether it is the pre installation inspection or the post installation commissioning inspection, the correct operating procedures must be strictly followed. Only the correct operating steps can make the product play an effective role in the use site.　　This can ensure that the water pump has been running at the best operating point, which not only meets the process needs, but also reduces the equipment loss, the traditional slurry pump cannot be installed and operated that is, and the submersible slurry pump can supplement this part of the blank work point.Where can I find it?,　　 Then tighten the compression nut on the packing gland evenly to make the liquid leak out in drops, and pay attention to the temperature rise outside the packing chamber.　　The Tao part also consumes part of it.　　 If it is found that the impeller is damaged and the liquid supply is insufficient, mechanical seals occupy an increasing share in the slurry pump seal market.Safety production,　　The structure of the submersible slurry pump will be more intuitive. First, the equipment will use centrifugal force to drive the liquid from the impeller to the outer edge and obtain energy, and then leave the edge of the impeller at a higher speed　　Stop the operation immediately under any of the following conditions: the current exceeds the rated value at the rated voltage; Under the rated head, the flow rate is much lower than that under normal conditions; Insulation resistance is lower than . megohm; When the dynamic water level drops to the pump suction; When the electrical equipment and circuit are out of specification　　Do a good job of fixing to avoid the motor falling into the water and directly scrapping.Zardabu　　It is longer and saves production cost. The whole industrial and mining system operates stably and will not affect the work of the whole industrial and mining system due to the operation of the pump. When the rotating speed of the submersible slurry pump cannot be changed and the lift is higher than the required equipment lift, the cut impeller is usually used. The cut is　　At the same time, the supporting pipelines in the pump room shall be provided with vibration isolation elasticity.　　The application of pumps involves all aspects of work and production, and the types of pumps are also diverse. Some of the same pump have several names, and some of the names are very similar, which makes it difficult to distinguish. Today, we will introduce the submersible pump and the submersible slurry pump. Is there any difference between the two