The rotor assembly is designed according to the actual situation, and the operation is more stable!　　After meters,Madinat HamadSingle suction slurry pump, the sealing of the equipment can not bear the water pressure at this depth.Madinat Hamad,　　 Operation management of sewage pump operation management of submersible pump adjust the liquid level to make the water pump operate at the best operating point. After the equipment is selected, the intersection of the characteristic curve of the water pump and the characteristic curve of the device is the best operating point.　　 When the power supply voltage is too low, the pump will be overloaded, because the pump is also widely used in many rural watering. In this case, it may be lower than the rated voltage, so the current in the stator winding will also beBayt Jala, a pressure gauge should be installed in this system to monitor whether the pressure meets the requirements.　　If the submersible slurry pump cannot be installed and operated, the blank operation point can be supplemented.　　Do a good job of fixing to avoid the motor falling into the water and directly scrapping.

　　Balance of.　　 No maintenance: if it is not used continuously after startup, the submersible pump will rust and cannot be started. If it is not used for a long time, when the temperature rises to a certain value, the water begins to vaporize and change from liquid to gas. On the contrary, at a certain temperature, the pressure drops toInspection environment,　　Adjustment. When using the submersible slurry pump accessories will be used and some auxiliary measures will be taken to improve the overall performance of the equipment and ensure the stable use of the equipment. Many users do not pay attention to these things when using them, which will cause equipment problems and affect work efficiency. So we&#;re using　　When the submersible slurry pump works, the pump needs to be placed on land, the suction pipe needs to be placed in water, and the pump needs to be started. Due to special structural requirements, when the slurry pump motor is submerged in the water, the slurry pump and submerged slurry circulating pump need to be placed above the water surface,Madinat HamadCarbon steel explosion-proof pipeline pump, so they need to be fixed, otherwise the motor will fall into the water　　 The working properties of the two pumps are also different. Because the sewage pump is driven by a motor it generally has good voltage impact resistance. The submersible pump is of the type of quick opening and quick closing,　　There are differences.　　The long shaft deep well pump is equipped with two types of motors: ordinary vertical Y series motor (equipped with PTS thrust disc) and hollow shaft YLB series motor for deep well pump. The insulation grade is divided into class B and class F. now, with the progress of science and technology and the continuous development of products, YLB series has developed high-voltage, protection and other grades up to　　The disc friction loss of the slurry pump impeller will decrease with the decrease of the impeller diameter, so that the pump efficiency of most low specific speed pumps will improve slightly after the impeller is cut. After cutting, keep the blades overlapped to a certain extent, and the degree of blade overlap will decrease with the addition of specific speedMadinat Hamad,　　Screw it down, and then remove the bearing inner race, O-ring, shaft sleeve and retaining sleeve in turn.　　 The pump body (can not) bear the pressure from the outlet pipeline system. The standby pump in the warehouse should rotate (/ times a week to make the shaft bear the load and external vibration evenly. The belt CR drive is that the motor is on the (right) side of the pump from the inlet of the pump.　　After a certain value, water will also vaporize, which is called the vaporization pressure of water at this temperature.