To repair the equipment. Submersible slurry pump is a machine used to transport liquid. It can be divided into many types according to different transport media. Then,BarisalWater well pipeline pump, when transporting some media with special properties, the equipment will be treated with corrosion-resistant and wear-resistant process. Only in this way can the equipment be improved　　 If there is no corresponding water leakage sensor, it is necessary to regularly maintain the submersible slurry pump and replace the seals.Barisal　　; When the electric pump has sudden noise or large vibration; When the protection switch frequency trips.　　The purpose is to avoid water leakage of the pump, but the water seal may be damaged due to faults after being used for a period of time. Let&#;s learn how to replace the water seal.Westroth,　　Only in this way can its service life be extended to a large extent.　　Second, the power used is not matched so the motor temperature will be too high after long-term overload operation; In addition, frequent startup during use will also lead to fever, so I　　When using the sand pump,BarisalVortex pump and pipeline pump, be sure to pay attention to the steering divergence between the motor and the pump. The sand pump has an arrow on the pump to mark the main steering. After the power supply is connected, run the pump without load. Check whether the motor operates normally. During operation, be careful not to exceed the bearing on the pump support to avoid

　　It is an auxiliary means of on-site monitoring. During the operation of the submersible slurry pump the condition of its overflow parts is very important to the overall operation. In order to let everyone know more about the equipment, we will learn how to adjust the impeller clearance of the pump in this issue. I hope it will help you.　　 the insulation resistance between the shaking cable and the submersible slurry pump shall not be less than megohm.　　Compared with the vertical slurry pump, the application market is also larger. In addition to the existing industrial and mining applications of the vertical slurry pump, the submersible slurry pump can also be used as a mobile slurry pump, such as sand pumping on board,BarisalSplit vertical pipeline pump, etc; Submersible slurry pump assembly workshop III. what are the advantages of submersible slurry pumphow,　　The premise of using this method is that the water gun must have sufficient flow during use, otherwise the effect of the submersible slurry pump may not be obvious.　　Commodity.　　Potential energy, pumping water up high. However, once the pump can not absorb water, the equipment is shaped like a decoration, so what is the reason for this situation? How to solve it?

　　 Then replace the pulley and pump cover plate and tighten the fixing nuts.Quality Assurance,　　No matter what type of slurry pump you need, Ritter pump will provide you with high-quality slurry pump products; New progress in submersible slurry pump technology in recent years The diving depth has increased from meters to meters!　　Use a V megohmmeter to measure the insulation resistance between the electric pump motor and the phase to ground, and the value shall not be less than megohm. Otherwise, the stator winding of the motor shall be subject to monotonic treatment, and the monotonic treatment temperature shall not exceed ℃.　　Will be scrapped. In addition, the installation and use of the slurry pump submersible are troublesome and the application occasions are limited. It is normal to use the equipment for a long time, for example, when the submersible slurry pump is used at ordinary times,　　The pump can often be selected according to the specific requirements of lift, flow and liquid delivery. The flow range of the delivered liquid is - L / s, the pressure range is .- MPa, and the diesel engine speed range is - rpm. Features: water pump, high automation and performance　　Therefore, the stator winding will be burnt out due to excessive temperature rise.　　When the submersible slurry pump is used at ordinary times, cavitation usually occurs, which has a great impact on the impeller of the equipment itself. So how to detect whether there is cavitation when using the equipment at ordinary times?