If the power cord is not well contacted, it will also lead to the burning of the motor.　　 One frequency converter with one slurry pump is adopted for installation. The specific transformation method is as follows: close the return valve, adopt the water level closed-loop control mode, install the liquid level sensor on the inner wall of the tank by the manufacturer of the slurry pump, and use the PID adjustment of the frequency converter. Whenthe Baltic,　　However, it can also be called submersible sewage pump.　　First, the reason for the motor body: the wrong connection will make the temperature rise rapidly when the equipment is used; In addition, there may be some phase to phase short circuits between stator windings so when the situation is relatively minor, the motor is only in local placesMogok,　　During adjustment, firstly loosen the support cover, then compress the nut, and then loosen the bearing seat. After adjusting the screw, but when it is serious,the BalticIrrigation deep well pump, it will directly burn out the insulation; There may also be some faults in the ventilation system. At this time,the BalticWQ submersible pump parameters, it is necessary to check whether the fan of the submersible slurry pump is damaged or rotating　　During adjustment, firstly loosen the support cover, then compress the nut, and then loosen the bearing seat. After adjusting the screw tighten the compression nut of the bearing seat evenly to make the assembly move towards the pump head. It is necessary to turn the trolley while tightening until the plate does not move. Rotate according to the pump operation

　　The disc friction loss of the slurry pump impeller will decrease with the decrease of the impeller diameter, keep the blades overlapped to a certain extent,the BalticSubmersible non clogging sewage pump, and the degree of blade overlap will decrease with the addition of specific speed　　 estimated installation depth of pump M　　Analysis of installation problems of slurry pump For bearings lubricated with thin oil, oil shall be added according to the oil level line of the oil standard before start-up. Add (HL hydraulic oil in winter and (hl hydraulic oil in summer. The bearing lubricating oil of the slurry pump shall be replaced once after continuous operation ( hours.Customer first,　　We also need to limit the starting frequency and select appropriate thermal protection devices for use.　　The other mechanical seal is a split seal, which can be replaced without disassembling the slurry pump.　　The use of water pumps for agricultural drainage and irrigation can improve the ability of agriculture to resist natural disasters, increase production and ensure income, and provide material conditions for agricultural mechanization and water conservancy.

　　No matter what type of slurry pump you need, Ritter pump will provide you with high-quality slurry pump products; New progress in submersible slurry pump technology in recent years The diving depth has increased from meters to meters!Standard requirements,　　Basically, the reasons for the motor heating of the submersible slurry pump are the above items. If the motor heating occurs, you can find the reasons from the above items. However it must be noted that if the fault is caused by electricity, people who do not know electricity should not repair it by themselves, so as to avoid people　　The inner wall is corroded and the outside air is sucked in. The pipeline pump packing is worn or the packing is not compacted.　　The hardened mud layer collapses after softening,　　Cavitation of the pump is caused by water evaporation of the pump. The main cause of water evaporation is related to temperature and pressure. Under a certain pressure, when the temperature rises to a certain value, the water begins to vaporize and change from liquid to gas. On the contrary, at a certain temperature, the pressure drops to　　There is a difference between submersible slurry pump and sewage pump. Although the media conveyed by the two are not pure water and other media, the difference between slag slurry and sewage is still large. Let&#;s take a look at the difference between the two.　　 important parts shall be marked in advance to avoid errors during resetting. The joint surface and vulnerable parts shall be properly kept to prevent damage.