The use of a lifting platform as a tool for storing performance blankets, soft scenery, etc. In some theaters, soft scenery,AlkmarXinmin, etc.When applying a normal force of N to any position on either side of the door using a rigid mm square or circular flat surface in the locked position of the landing door the door should be able to withstand and have no deformation; - Deformation not exceeding mm; After the test, it worked normally.Alkmar,Construction electric elevators should be equipped with upper limit switches that are sensitive and reliable.Setting requirements: The verticality deviation of the installation of the guide rail frame of the construction electric elevator should comply with the requirements of the user manual and specifications, as specified in the above table.Neiba,Model Example: Hanging Cage Specification: LABSC/TDx Type I: ~ Type II: ~ Type V: ~ Technical Requirements: The load-bearing capacity of the foundation should be greater than P: P=(hanging cage weight+outer cage weight+total weight of guide rail frame+counterweight+load) x. (kN).Setting requirements: The main connection methods between the wall bracket and the building include: connecting the wall bracket with the embedded parts on the wall; Fix with wall bolts; Embedded bolts; Welding with steel structures.The counterweight guide rail should meet the specification requirements.

Setting requirements: The foundation and foundation of the construction electric elevator should meet the requirements of the user manual. Before installing the construction electric elevator the foundation should be inspected and accepted according to the requirements of the specifications. Only after passing the inspection can the installation be carried out.Aluminum alloy lifting platforms can be divided into single column aluminum alloy, cargo elevator, double column aluminum alloy, three column and four column aluminum alloy. Can be used in factories, automated warehouses, parking lots, docks, buildings, and installationsConstruction electric elevators should be equipped with cable guide frames and comply with regulatory requirements.Create brilliance,From the above comparison, it can be seen that hydraulic electric lifting mechanisms have stable lifting, low noise, long service life,AlkmarUdinese, large load bearing capacity, and are relatively simple, making them suitable for use in stage equipment.It is reported that a fixed electric elevator has good lifting stability and can only be used for fixed operations, making high-altitude operations easierThe end height of the guide rail frame above the high attachment point should comply with the provisions of the user manual.

In addition to ground protective fences, low level doors can be used. Low level doors should meet the following requirements: the height of the door should be between m and m. And there should be at least protective railings, a half height middle crossbar, and a toe board at least mm above the ground.market price,Emergency manual valve: In case of power failure, it can cause the car to descend to the nearest floor position and open the doorWhen a single steel wire rope is excessively stretched, the Electrical safety device shall stop the operation of the electric lift.Operating cost advantage and low failure rate: Due to the use of advanced hydraulic systems and good methods, the operating failure rate can be reduced to a low level.Alkmar,Setting requirements: The installation and dismantling workers, and other operators of construction electric elevators should have special construction operations.Horizontal lead screw mechanical electricitySetting requirements: The anti loosening and anti loosening parts between the connecting parts should comply with the provisions of the user manual and should not be replaced by other objects. For connecting bolts with pre tightening requirements, a torque wrench or special tool should be used to accurately tighten the bolts to the specified torque value according to the specified tightening sequence. When installing standard section connecting bolts, it is advisable to place the screw at the bottom and the nut at the top.