Rate.　　 Another possibility is that the gas is sucked in when the pump is in use.Ramadi,　　 water　　Rate.Aviles,　　Is called cavitation phenomenon.　　Generally speaking, the above two cases are the case that the slurry pump does not absorb water. The solutions are also introduced. I believe that people can deal with this problem in time. However, if the problem is serious,RamadiRubber lining submerged slurry pump, you must not adjust it at will. At this time, you should find a professional　　 To ensure the efficient operation of the submerged slurry pump, the clearance between the impeller and the front guard plate must be adjusted regularly to keep it between (.-mm). In addition to monitoring the flow and pressure during the operation of the pump, the motor shall not exceed the rated current of the motor. Monitor oil seal and bearing at any time

　　Under the action of auxiliary devices,RamadiSewage pump diving, it can transport the slurry, and because the sealing device itself is special, so that the pressure at both ends of the equipment can be balanced during normal use　　And it shall be used according to the quota specified in the manual.　　 There is also a vibration method to measure the vibration frequency of the pump, when using one method, the measurement results may have some errors. When using the submersible slurry pump, there are other vibration sources that will affect the measurement results so it is actually the mainnew product,　　At present, mechanical seals occupy an increasing share in the slurry pump seal market.　　Moreover because the length of the long shaft is generally fixed,RamadiISG single stage vertical pipeline pump, it is often troublesome to install it. Therefore, when it is used later, the place where it operates will also be limited. If the equipment will　　Different process requirements: the motor used in the vertical slurry pump is an ordinary vertical motor, which has no waterproof . The motor of the submersible slurry pump and the pump shaft are coaxial. The motor shall be waterproof and sealed. The motor and the pump body can invade underwater at the same time.

　　At the same time, the supporting pipelines in the pump room shall be provided with vibration isolation elasticity.system,　　If the pressure in the local area is equal to or lower than the vaporization pressure corresponding to the water temperature in the flow process, the water will vaporize there and form many small bubbles mixed by steam and gas. The cavitation phenomenon is due to the bubble action when these small bubbles flow from the low-pressure area to the high-pressure area in the water pump,　　In order to make it convenient for you to know this excellent submersible sewage pump, which is often used. Please look at the following content.　　 The working properties of the two pumps are also different. Because the sewage pump is driven by a motor, it generally has good voltage impact resistance. The submersible pump is of the type of quick opening and quick closing, so it usually uses some small Flow and small pressure.Ramadi,　　It is located in the middle, so it seems that many regions have good effects when using it.　　The whole packing body, including the packing gland, packing ring and packing, needs to be disassembled; Submersible slurry pump Disassemble the o-seal ring, shaft sleeve, balance disc and key on the shaft in turn, and then the discharge section includes the last stage guide vane　　 The difference between the vertical slurry pump and the submersible slurry pump The working position of the vertical slurry pump is different. The vertical slurry pump is partially immersed in the pit and cannot be completely immersed in the liquid level. The submersible slurry pump can be completely immersed (including the motor part) below the liquid level; Use of motor for vertical slurry pump