In the morning trading today, the price of domestic copper bar fell. According to the monitoring data of Lange Steel s cloud business platform, the average price of * mm hot rolled strip in key cities in China is , down yuan from yesterday. Futures prices fluctuated, and the prices of spot market manufacturers eased slightly today. According to the feedback,Shi TA Fang Dan310s stainless steel coil, the market was mainlysee yesterday, which caused the overall transaction blocked, and the mainstream manufacturers prices fell today.To sum up, the market in Northeast China is generally pessimistic based on the medium and long-term policies and the general environment, as well as the current inventory level in Shenyang. The low inventory level of copper platoon makes the whole market lack of motivation. The copper bar market in this city has stopped this year, and it is hard to improve in the short and medium term. On the whole the market price of Shenyang copper bars may be stable tomorrow.Shi TA Fang Dan,Four in one formula and process conditions Preparation of solution Take formula as an example: mix the calculated amount of water for zinc oxide into a paste, slowly add it into the calculated amount of phosphoric acid under stirring until it is completely dissolved, dilute it with water to / of the total volume, add sodium alkosulfonate and OP emulsion, and stir to make it completely dissolved. Then add chromium dihydrogen phosphate dissolved in dilute phosphoric acid, and add titanium sulfate. After all materials are added, dilute them to the total volume, stir them to make the solution even, cool them to room temperature, put a large amount of iron filings in the solution, and soak them for - days to make them contain enough ferrous ions. When the content of ferrous ion reaches above g/L, adjust the free acidity and total acidity of the solution to the specified value, and then the solution can be used at elevated temperature. When the ferrous ion reaches the above value, the solution is stable, and the phosphating film is fine and dense. During operation, attention shall be paid to controlling the temperature. If the temperature is higher than ℃, the degreasing technology of degreased copper pipe. How to make degreased copper pipe? The process flow of degreased copper tube? What are the characteristics of degreased copper tubes? Use of degreased copper tube? There are too many questions. Let s solve them at once. Everyone knows the copper tube. Nitrate reacts easily. The heater should be installed on the two walls of the tank, not on the bottom of the tank, and lead pipe or copper pipe should not be used to avoid contamination of solution by impurities. What is degreased copper pipipe? & amp; quot; The advantages of degreased copper pipe s comprehensive treatment of grease, rust removal, phosphating and passivation are described. This comprehensive treatment process can simplify the process reduce the work area, save equipment costs, shorten working hours, improve labor productivity and reduce costs. This method can only be used in the occasions where the requirements for coating quality are not high. However, due to the amount of oil contamination, light and heavy rust, the consumption rate of each component in the solution is different, so attention should be paid to adjustment and control to maintain its due role. What is the degreasing copper tube? & amp; quot; I have roughly known the degreasing methods of degreasing copper tubes: solvent degreasing, alkali degreasing, ultrasonic degreasing, high pressure hot water degreasing, electrolytic degreasing, etc. Solvent degreasing: use degreasing solvent to dissolve the oil on the surface of red copper pipe, collect it together into a container, volatilize, collect and reuse the volatile solvent, and separate the pollutants from the circulation system. This method was used in the early stage, which has problems such as low cleaning efficiency, difficult maintenance, and environmental pollution. In recent years, many kinds of surfactants have been developed. The lipophilic group of surfactants can help to dissolve oil in water to realize degreasing. Alkali degreasing: Alkali degreasing is a complex chemical physical process. In addition to saponification reaction, there are sometimes emulsion reaction and adsorption reaction. Typical saponification reaction formula is as follows: RCOOH+NaOHRCOONa+HO At present, industrial degreasers are composite reagents, and the solution temperature is ℃. Ultrasonic degreasing: ultrasonic degreasing is to degrease the upper and lower surfaces of red copper pipes by using ultrasonic to generate high-speed vibration, whichtly used for monomer and irregular shaped components. High pressure hot water degreasing: without degreasing agent, heat the deionized water to ℃, and spray it directly to the surface of red copper pipe for cleaning under the pressure of about bar. Electrolytic degreasing: electrolytic degreasing, using the red copper tube as the cathode to generate H, which will scour the oil stain on the surface of the red copper tube; The O generated by the anode is in atomic state and has strong oxidation capacity, which can improve the degreasing effect. Therefore, the problem that alkali spraying and brushing cannot fully contact the micro concave part of the surface is solved. Generally, the cleaning effect of alkali degreaser spraying or high-pressure hot water degreasing plus brushing can meet the requirements of most users. If there are special requirements, multiple methods can be used together. According to practical experience, the degreasing effect of various degreasing methods (one side of the copper tube) is as follows: alkali degreaser spray plus brushing: mg/m alkali degreaser brushing plus electrolytic degreasing: mg/m ultrasonic wave: mg/m high-pressure hot water degreasing:& lt; mg/m degreasing copper tube What is the degreasing purpose of the degreasing copper tube? The purpose of degreasing is to provide a clean surface for the copper pipe and lay a foundation for the subsequent process of coating. What is degreased copper tube? & amp; quot; We learned about the cleaning degree detection method of degreased copper tube: Visual inspection. Wet the degreased workpiece surface with water, and determine the cleanliness according to the complete adhesion of the surface water film. This is the most commonly used method to detect the degreasing quality. Wipe method. Wipe the degreased and dried workpiece surface with clean white silk cloth or filter paper. If there is no oil stain on the surface of filter paper or silk cloth, take the workpiece out of the solution after min, and wash it with water. Degreasing red copper pipe shall be evaluated for cleanliness according to the copper film. The copper film is complete and uniform, with good luster and adhesion, indicating that there is no oil stain on the surface of the workpiece. This method is suitable for small workpieces.Copper tube is also called copper tube nonferrous metal tube. It is a pressed and drawn seamless pipe, characterized by light weight, good thermal conductivity, high low-temperature strength and corrosion resistance. Because of these excellent properties of copper tubes, the use of copper tubes is very common. What are the differences between hard copper tubes and soft copper tubes in the use process? What are the differences between the two in terms of specific applications?Ambalavao,Copper tube is a kind of nonferrous metal tube, which is pressed and drawn seamless tube. The copper pipe has good thermal conductivity, and is solid and corrosion resistant. It will not crack when compared with the ambient temperature, so it becomes the first choice for modern contractors to install the water pipe, heat supply pipe and refrigeration pipe in all residential commercial houses.Red copper bars in other regions basically follow the price trend of Tangshan, in which the bid of Jiangsu Steel Works tends to be higher, and most of the downstream prices are asked, and the overall market transaction is fair. The steel mills in Wu an are limited in receiving orders, and the market resources are tight. Most of the merchants are reluctant to sell. Shanxi billet market offers vary, and it is difficult to clinch a deal. The willingness of downstream customers to receive orders is weak, so they hold a cautious wait-and-see attitude. At prepresent, the steel market is in the & quot; golden third& quot; peak season. The market has a good expectation of the future market and a strong willingness to support prices. It is expected that the prices of Tangshan mainstream billets will be stronger next week.Copper pipe has the characteristics of, and is the choice for the installation of water pipe, heat supply and refrigeration pipe.

In the middle and late ten days, although there were good news such as the rise of futures and the increase of production restriction policy in Wu an region, due to the high inventory level, traders had no desire to increase prices, most of them had shipped goods, but the total pressure is not big. From the current overall inventory situation of the main distribution centers Wu an and the continuous rise of inventory led to the empty market mentality.Many people do not fully understand the storage method of copper tubes in the process of use and production methods.Red copper inventory in key areas has risen continuously, Jiangyin and Lecong, the inventory level remains relatively moderate, and the pressure on the market is relatively small. In Wu an market, according to the data, as of May , the total inventory of medium and thick plates in Wu an was close to tons increasing by tons on a weekly basis. In late April, it reached tons lower in the year down tons from the high level after the Spring Festival, and rose for three consecutive weeks. In terms of the ovquantity, it should be said to maintain a relatively moderate level.Pursuit of excellence,In the middle and late ten days, although there were good news such as the rise of futures and the increase of production restriction policy in Wu an region, due to the high inventory level, traders had no desire to increase prices, and spot prices lacked motivation to rise. The market inventory rose significantly. At that time, the market inventory in Handan reached a high level after the festival. The sluggish demand performance for a long time led to the oversupply of the market, and the continuous rise of inventory led to the empty market mentality.For small diameter pipes, when using filler metal, the length of filler metal is allowed to be equal to the diameter of the pipe, which is enough to fill the weld crater. One of the five major application fields of red coppr plate T, motors and transformers accounting for more than half of the total consumption. Used for various cables and wires, switches and printed circuit boards; In the manufacture of machinery and transport vehicles, it is used to manufacture industrial valves and accessories, instruments, sliding bearings, molds, heat exchangers, pumps, etc.If the corrosion on the copper surface is found to be slight, it can be erased with linen copper wire, but it is not recommended to apply oil for preservation.

When welding, just add enough filler metal to fill the capillary gap. Too much filler metal will only form a ball at the bottom of the joint or run into the pipe.Promise and keep promise,In the morning trading today, the price of domestic copper bar fell. According to the monitoring data of Lange Steel s cloud business platform, the average price of * mm hot rolled strip in key cities in China is , down yuan from yesterday. Futures prices fluctuated, and the prices of spot market manufacturers eased slightly today. According to the feedback, the market was mainlysee yesterday, which caused the overall transaction blocked, and the mainstream manufacturers prices fell today.The above two types of thermal connection usually use the term welding,Shi TA Fang Dan316L stainless steel pipe, because in both cases,Shi TA Fang DanRed copper bar, molten solder is written into the narrow gap on the clean and close solid metal surface of the two devices to be installed.On the other hand, in the steel plant, the lock price of the steel plant has been falling all the time, and the order receiving is poor. The capacity utilization rate of the steel plant is low, but the market is still in oversupply. The stock of the steel plant and the spot stock are both risirising, so the market price has fallen sharply. Subsequently, the futures market rebounded in a wave, and the spot price also increased with the increase. There was an instant of large volume of transactions. However, with the decline of black futures, the market transaction volume shrank significantly. In addition, the inventory pressure was high, traders shipped at low prices, and the spot price fell under pressure. Due to the strong drop resistance of medium and thick plates, the drop amplitude and rate are less than those of threads.Shi TA Fang Dan,Although the opening continued the weak trend, the intraday transactions improved and the prices of some copper bar manufacturers rose. From the specific situation, although the manufacturer feedback that the shipment is average, the mentality is relatively calm, the market inventory is not much, and the manufacturer is not willing to significantly reduce the price. In terms of the market, the transaction of strip steel is better than other steel varieties and the downstream mainly focuses on callback buying without panic inventory clearing. It can be seen that although the steel market continues to shake, the overall demand for strip steel remains in a good state.When stacking, it shall be stacked reasonably and placed first.In view of the current overall price difference the local copper bar price continued to rise at a high level today, while the regions outside East China did not show an obvious follow-up trend, and the local price still has the advantage of price difference with the Northeast and Central China regions. The local inventory pressure will be further reduced due to the small volume of local follow-up goods under the influence of production restriction, and the price support of copper bar is still strong. However, at present, domestic real estate control is still being tightened. The market s expectation of future demand is weakening, the market price of copper bars in Shenyang is stable and the shipment is poor.