SalsalsalleNiuli brand electric elevator,

The bearing capacity of the ground under the concrete foundation plate should be greater than .Mpa.The bearing capacity of the ground under the concrete foundation plate should be greater than .Mpa.Salsalsalle,The safety overtravel of limit switches and upper limit switches should comply with regulatory requirements.When the foundation is set on the roof or floor structure, the bearing capacity of its supporting structure should be checked.Macenta,Drainage measures need to be considered around the foundation. (Drain the accumulated water on the foundation).Setting requirements: When the distance between the outer edge of the construction electric elevator and the external overhead power line cannot meet the requirements of a small safety distance, the protective measures taken should comply with the specification requirements.Drainage measures need to be considered around the foundation. (Drain the accumulated water on the foundation).

When the wall bracket adopts non matching standard products design calculations should be carried out.When adding hydraulic oil,SalsalsalleElectric elevator, we can extend the oil cylinder to the high position for filling. When filling the lifting platform should not exceed the high position, and then retract the oil cylinder back to the low position to check if the hydraulic oil level is lower than the low position, and maintain it between the two.The entrance of each landing platform must be equipped with a landing door, which must open towards the landing platform side, and the door bolt must be set on the side next to the construction electric elevator.wholesaler,Braking. The brake limit switch for partial motion control of the electric hoist traction machine. Assembly that restricts the operation of the lift car when it is opened to a high or low position; If the limit switch controls the overtravel switch. When the car travels to a high or low position, it will take on the function of raising or lowering. In order to prevent the lift car from crashing or sinking, stage equipment should be dismantled with over travel switches that can cut off power and cannot be automatically reset, and installed in the machine room, rather than in the shaft; A buffer should be installed that can absorb the energy of the moving mechanism and reduce impact.Setting requirements: The guide rail should be rigid and flexible components such as wire ropes or chains should not be used.Drainage measures need to be considered around the foundation. (Drain the accumulated water on the foundation).

The bearing capacity of the ground under the concrete foundation plate should be greater than .Mpa.Packaging strategy,When the door is closed, except for the gap between the lower part of the door that should not exceed mm,SalsalsalleMobile electric elevator, as well as the gap around the door or the gap between parts, should comply with the provisions of Table of GB -.If the set screw is loose, be sure to pin it tightly to prevent accidents caused by the shaft pin falling off. Hydraulic oil should be kept clean and replaced every months.The counterweight guide rail should meet the specification requirements.Salsalsalle,The setting of the cable guide frame should comply with the user manual and regulatory requirements.Low level doors should be equipped with interlocking devices that can verify their closed and locked positions. The action of this interlocking device should be at the entrance of the cage. Simple use should not interfere with the operation of the interlocking device. The attached wall bracket should use matching standard products. When the wall bracket cannot meet the requirements of the construction site, it should be designed separately. The design of the wall bracket should meet the requirements of component stiffness, strength, stability, etc., resulting in a safety clamp. To prevent breakage of the lifting wire rope. A safety clamp that can simultaneously cut off the power supply and stop the car from falling should be removed from the car. A car without safety tongs is not allowed to ride or carry people. If it is a simple electric elevator, there should be a safety device (such as a safety stop pin) to prevent people from suddenly falling when loading and unloading goods in the car; Electric elevators with three or more floors (including three floors) for passengers or passengers.