Methods of exerting efficiency in application of C-section steelThe finished product has smooth surface, low friction coefficient flatness error + / - mm / m length, wear resistance and maximum temperature of ℃Whitnango, Application of galvanized pipeBecause alloy pipe is a very unique pipe fitting we must use appropriate methods to carry out installation in the case of installation, so as to ensure the performance index of the data. Generally, when installing alloy pipes, we will use some flanges and elbows to fix them, so as to ensure that the raw materials can be fixed very well. Therefore, when we carry out use, we must ensure the quality of flanges and elbows, so as to ensure the actual effect of alloy pipe assembly. If there are instrument panel components that must be assembled on the pipeline, they must be installed together.Eritrean, The defects can be removed by grinding with sand wheel, but the remaining wall thickness must be within the allowable standard. Direct rolling pass system. The direct rolling pass system refers to the pass system in which the two open legs of the I-beam pass are on the same side of the roll axis at the same time, and the waist is parallel to the roll axis.a. In the forming process,WhitnangoHow much is 50 galvanized pipe per meter,WhitnangoWhat software is used for steel bar turnover, the thick steel plate has uniform deformation, small internal stress and no scratch on the surface. The alloy pipe produced and processed has higher coordination ability in the scope of size, specification and model of diameter and wall thickness, especially in the production and manufacturing of steel structure design grade thick wall pipe, especially medium diameter small thick wall pipe, which has incomparable advantages of other processing technologies, and can meet a large number of customer regulations on the specification and model of alloy pipe.

Patented manufacturing process of I-beam: I-beam has become a new industrial standard for wear-resistant materialsWhat are the advantages of seamless pipe?What is nitriding of alloy pipeoffer, Direct rolling pass system. The direct rolling pass system refers to the pass system in which the two open legs of the I-beam pass are on the same side of the roll axis at the same time, and the waist is parallel to the roll axis.When selecting I-beam in structural design, reasonable I-beam shall be selected according to its mechanical properties, weldability and structural size.Mixed Scabs are distributed periodically, and the situation after casting and rolling is significant through edge flame peeling crack inspection or billet scratch flame removal.

When selecting I-beam in structural design, chemical properties, weldability and structural size.demand,According to the national standard of hot rolled H-section steel in China (GB / t-, H-section steel is divided into narrow flange,WhitnangoHot dip galvanized welded pipe factory, wide flange and steel pile, whose codes are Hz, HK and Hu respectively. Narrow flange H-section steel is suitable for beams or compression bending members, while wide flange H-section steel and H-section steel piles are suitable for axial compression members or compression bending members. Compared with H-section steel, W, IX and iy are not as good as H-section steel under the premise of equal weight. Operating conditions The defects can be removed by grinding with sand wheel, but the remaining wall thickness must be within the allowable standard.Whitnango