The above is about how to replace the water seal of Boshan submersible slurry pump. In addition to the water seal, some parts of the pump are relatively easy to be damaged, so we need to replace them regularly during use Check whether it needs to be replaced. The pump body (can not) bear the pressure from the outlet pipeline system. The standby pump in the warehouse should rotate (/ times a week to make the shaft bear the load and external vibration evenly. The belt CR drive is that the motor is on the (right) side of the pump from the inlet of the pump.Soroka, The inner wall is corroded and the outside air is sucked in. The pipeline pump packing is worn or the packing is not compacted. The pump can often be selected according to the specific requirements of lift, flow and liquid delivery. The flow range of the delivered liquid is - L / s, the pressure range is .- MPa, and the diesel engine speed range is - rpm. Features: water pump, high automation and performanceManavgat, selection of pump head: generally, the pump head shall be determined by enlarging the margin of % - %. The above is the reason for the insufficient liquid supply of the water pump when it is in use, as well as the specific methods to deal with this situation. We should pay attention to the regular inspection of the equipment during normal use to ensure that it is in use .
Many users, including new practitioners of slurry pumps, often fail to distinguish the difference between submerged vertical slurry pumps and submerged slurry pumps. The names of submerged and submerged slurry pumps seem similar but there are essential differences. What is the difference between submersible slurry pump and vertical slurry pump? D. G-type slurry pump is a single pump shell structure, that is, without lining, cover and impeller shall be made of strong wear-resistant high chromium alloy or wear-resistant alloy steel, and the hardness shall not be lower than hrc. The connection of pump body and pump cover adopts special clamping structure, and the pump outlet direction can be rotated freely, Submersible slurry pump can be widely used in mining, power, metallurgy, coal, environmental protection and other industries to transport abrasive slurry containing solid particles. Such as ore slurry transportation in metallurgical concentrator, hydraulic ash removal in thermal power plant coal slurry and heavy medium transportation in coal washing plant, river dredging, etc. In chemical industryOnline consultation, Prepare tools and materials: a set of metric box / open-end wrench, bearing puller (commonly known as triangle puller), magnetic dial indicator, outside micrometer, caliper, feeler gauge, square ruler, copper bar, screwdriver with handle, hammer, V-shaped irons of the same specification, clean kerosene, oil basin,SorokaDeep well submersible pump, cotton yarn,SorokaSingle stage slurry pump,SorokaHorizontal non clogging sewage pump, etc. After that, before starting again, check whether the impeller rolling is normal and whether the bearing assembly compression bolts are tightened, and then start the pump. After meters, etc., and handle it at any time.assets, There are differences. Shaft seal part auxiliary impeller shaft seal: through the impeller action of a reverse centrifugal force, the single-stage pump or the first stage pump in series can adopt the auxiliary impeller shaft seal, and the auxiliary blade shaft seal is not required Inspection before installation: Check the specification, size and quality of thick and thin accessories.Soroka, Second, the service life of the flow passage parts of the pump is relatively long, saving production costs. Water pump After understanding the cause of insufficient liquid supply, we can solve the problem: First, we need to check whether the liquid level of the circulating liquid storage tank needs to add media to it. The high-efficiency slurry pump has three characteristics: first, the slurry pump has high operation efficiency and low loss.