Defects: poor wear resistance, no fire prevention, no corrosion resistance, very easy to regain moisture, deformation thermal deformation, folding, etc.,Tilgu MuresCan I have a wooden floor in the kitchen, and must be polished and waxed on time, which is difficult for medical treatment.durabilityTilgu Mures,Then select one or more floor waxes, which can be adjusted to the same tone as the floor.Heat the strip solid recovery wax with an electric soldering iron and fill it on the scratches on the floor. No scratches can be seen. About strengthening the floor.Shakhty, Look at the section of the board. Domestic cheap decorative paper is usually used. The pattern of this decorative paper is fuzzy. The biggest defect is that it is generally not UV resistant and will fade after sunlight.This is why some consumers reflect the discoloration of the places near the balcony and windows three or four months after the floor is installed. The base material is poor, medium and low density board or particleboard is used the quality index is unstable, and the formaldehyde seriously exceeds the standard. SPC floor surface will not have holes and water seepage;There will be no seams after splicing. After being stained, wipe it gently with a rag to clean it easily, leaving no marks that are difficult to remove, and there is no need to maintain it with special maintenance products.
Rich colors and patternsInspection results:In order to prevent local fading due to frequent sunlight exposure, it is best to hang curtains to turn direct light into diffuse light, which is conducive to prolonging the service life of the floor. Pay attention to the fact that hard substances such as metal sharps and shoe staples are easy to scratch the surface of the worn lacquer cloth. Avoid cigarette butts, boiled water and hot objects above ℃ from directly contacting the plate surface. Prevent burning marks and scalding marks. Do not press the surface with rubber pads for a long time,In case of indentation, it is difficult to remove. Although the ground lacquer cloth is flame-retardant and self extinguishing, it will decompose harmful gases at high temperature, which will suffocate if inhaled too much. First, pursue foreign goodsdiscount, Test: for the ground lacquer cloth with thin thickness, you can tear it by hand. If it can be easily torn off, the tear strength of such ground lacquer cloth can not meet the requirements. After gently rolling up and pressing down, such a product has poor softness.If the layers can be torn by hand, it indicates that the product layers are not well combined, and stratification will soon occur in future use.Plastic floor paint cloth has the advantages of light weight, elasticity,Tilgu MuresHome floor leather, good mechanical strength, good foot feeling strength, comfortable foot feeling, wear resistance, pollution resistance, corrosion resistance, heat insulation, sound insulation, moisture resistance, small water absorption, good insulation, self extinguishing, easy cleaning, simple construction, convenient maintenance and low price. In a large number of civil buildings and public places it has high requirements for cleanlinessIt is widely used in the laboratory.Plastic floor paint cloth belongs to soft floor. It is a floor coil produced by coating or calendering on sheet continuous substrate with polyvinyl chloride resin as the main raw material and appropriate additives.The length of each roll of plastic floor paint cloth is m ~ m, the width is mm ~ mm ~ mm, and the total thickness is mm (machine room) ~ mm (plant and public buildings)For long-term indoor use, high and medium grade products should be selected, especially foamed leather, which gives people a comfortable and elegant feeling. If you want to use them for a short time or one-time cover, because low-grade productsThe price is low and there are many prices to choose from, but many of these products are processed with waste materials, with poor flexibility, generally thin thickness and large shrinkage coefficient. When checking the appearance quality of rubber plastic floor paint cloth, it should be under scattered sunlight or fluorescent lamp, and the illumination should be ( ± LX, LM from the tested sample, conduct oblique visual inspection. First, observe whether there are cracks, fractures and delaminations on the surface of the local lacquer cloth. If there are, it can be judged that the local lacquer cloth is unqualified. The second step is to observe whether there are wrinkle marks, or if there is any defect of the transparent wear-resistant film on the surface, it is the first-class product and the first-class product. If there is a slight missing print or lack of film it is the qualified product, otherwise it is the unqualified product. Finally, carefully check whether there is deviation in the multi-color overprint on the surface, whether there is color difference in different parts, if the top-class product is uneven if there are the above two defects,Tilgu MuresTop 10 flooring brands, but if there is no obvious, it is the first-class productProducts that obviously have the above defects but do not affect the overall beauty are judged as qualified products. Finally, the appearance quality of ground lacquer cloth is determined based on the above judgment. When selecting ground lacquer cloth, first smell whether it has pungent smell. There will be a slight smell after the good coil is opened, and the smell of inferior products is stronger; secondly, calculate the use area, and the same room should be selectedCoiled materials with the same batch number, carefully observe the appearance quality, open a roll of ground lacquer cloth, separate the ends for a few meters, observe the surface layer of the sample, the surface layer is thick, the wear-resistant layer is thick, and the service time is long, and then observe whether there are cracks, fractures, wrinkles, bubbles and large defects; whether the cross section is layered and cracked; whether the pattern is open, missing, lack of film and overprint deviationDefects such as color difference, color difference and pollution.The wide board specification was invented by Chinas laminate flooring processing enterprises in order to meet consumer demand. Its advantages look generous, and there are relatively few gaps in the floor. Most of them are thickened, that is about mm. Generally, the decorative paper on the surface is made in China, with many changes in design and color, which is more flexible. The disadvantage is that the color difference is relatively large, and the anti ultraviolet ability of the decorative paper is poor.Advantages: of course, the grain is comfortable, wear-resistant, corrosion-resistant, moisture-resistant, flame retardant, and the maintenance is better than that of solid wood.Suitable soil temperature, can also be paved in the kitchen.
Compared with WPC flooring the price of SPC flooring is reasonable.However, you must choose one that suits your requirements.Its better to spend more money on the floor you need, rather than low-cost floors.How to deal with furniture when replacing a new floor?In order to install a new floor, furniture and items must be removed.Professional laminate flooring must be installed in this process.The exact method you choose for furniture depends on several factors.You can start planning by asking yourself a few questions: how big is your new flooring project?Are you going to lay new floors in one room or the whole house?Online consultation, If the outdoor humidity exceeds the indoor humidity, close the windows and doors to maintain a low humidity in the room. If the outdoor humidity is lower than the indoor humidity, open the windows and doors to reduce the indoor humidity.In case of cold and humid temperature, central air conditioning or electric fan can be used.Different colored floors can create different styles of popular furniture, high-grade, calm, classical and unique furniture charm.Exquisite life starts from decoration. If you want to have a family environment with both appearance and quality, you need a combination of styles. The decoration style has a great relationship with the choice of floor color.Therefore, to create such high-quality and textured home decoration, we must not damage the floor.Install basketball wood flooring manufacturers flooring?Sports wood flooring installation basketball wood flooring manufacturers now have many unprofessional basketball wood flooring manufacturers.In order to reduce costs, they will not hesitate to damage the interests of customers, reduce costs, and cause the floor to slip.Strengthen the floor color, fully meet the needs of personalized design, with many varieties and fashionable colors, which can simulate various natural or artificial patterns.The decorative layer of laminate floor is generally imitated by computer, which can imitate wood patterns of various materials, or stone to make unique patterns that are not available in nature.Tilgu Mures,Formaldehyde damage.Solid wood flooring is made of natural wood materials, which is integrated without production and processing. Of course, it accepts the unique characteristics of wood, which is easy to arch and deform.Production and processing of composite flooring is generally not easy to happen.The water resistance is reflected by the water absorption thickness expansion index. If the index value is high, the water resistance is poor, it is easy to cause size change in humid environment.Must not listen to the misleading such as waterproof floor, only moisture-proof floor, no waterproof wooden floor.